Bar Clamp GEKO G29965 — woodworking strap clamp 4 m × 2.5 cm XL

The GEKO G29965 bar clamp is a woodworking strap clamp designed to apply even pressure across wide or irregular-shaped workpieces. Its XL strap reaches 4 m in length and measures 2.5 cm in width, enabling secure holding of large panels, frames and assemblies during glue-up, laminating and finishing operations. The clamp combines a compact frame with a flexible strap to wrap around assemblies where conventional bar clamps cannot reach.

Advantages

This woodworking strap clamp provides uniform clamping pressure over a broad area, reducing the risk of localized crushing or distortion on soft or veneered surfaces. The extended 4 m strap allows handling of oversized or awkwardly shaped workpieces, while the 2.5 cm width balances strength and flexibility for reliable tensioning. Its compact hardware simplifies storage and transportation in a busy workshop.

Suitable for

• Gluing and laminating large panels and boards
• Securing frames and door or window assemblies
• Holding irregular or round workpieces during assembly
• Applying uniform pressure to veneered surfaces
• Temporary bundling and positioning of multiple components

Key specifications

• Strap length: 4 m
• Strap width: 2.5 cm
• Type: woodworking bar/strap clamp
• Intended use: wide-area pressure distribution for gluing and assembly

How to use

Wrap the strap fully around the workpiece or assembly so that pressure is applied evenly across the glued surfaces or joints. Feed the strap through the clamp mechanism and tension gradually until the desired compression is reached, taking care to align glued edges and maintain square or flat surfaces as required. Release tension slowly when the glue has cured or the operation is complete. Store the strap neatly coiled to avoid kinks and inspect before use for wear.

Usage recommendations

For best results, place protective pads between the strap and delicate surfaces to prevent marking, and tension incrementally to achieve even compression. Check strap condition before each use and avoid over-torquing to prevent damage to workpieces and the clamp mechanism.