Wood Paddle Drill Bit GEKO G37312 24 x 152 mm HEX shank

Paddle (spade) drill bit GEKO G37312 24 x 152 mm with HEX shank is designed for drilling clean-through and clearance holes in soft and hardwoods, plywood and other common wood-based materials. The flat paddle head removes chips quickly while the central point helps position the bit accurately. The hexagonal shank provides a secure grip in power drills, impact drivers with adapters and quick-change chucks, reducing slippage during high-torque use.

Advantages

The flat paddle geometry facilitates fast chip evacuation and efficient cutting. A sharpened cutting edge and centered point ensure accurate starts and reduced wandering on the workpiece. The HEX shank increases retention in the chuck and is compatible with quick-change adapters, improving workflow when switching bits. The overall length offers good reach for through-holes in boards and panels.

Suitable for

• Drilling through-holes in softwood, hardwood and plywood
• Carpentry and joinery tasks such as creating holes for bolts, screws and dowels
• General woodworking and on-site installation work

Key specifications

• Cutting diameter: 24 mm
• Total length: 152 mm
• Shank type: hexagonal for secure grip and quick-change compatibility
• Head type: flat paddle (spade) with central point and sharpened cutting edges
• Intended material: wood and wood-based materials (plywood, chipboard)

How to use

Mark the drilling position and secure the workpiece to prevent movement. Fit the hex shank into the drill chuck or quick-change adapter and tighten securely. Start drilling at low speed to allow the central point to locate the spot, then increase speed and apply steady pressure. Clear chips regularly if drilling deep holes to avoid clogging. Withdraw the bit periodically for chip removal when drilling thicker material.

Usage recommendations

Use appropriate drill speeds for the type of wood: lower speeds for hardwoods and higher speeds for softwoods. Wear eye protection when drilling and clamp small or thin workpieces. For cleaner hole edges, consider backing the wood with a sacrificial board before drilling through.