Drill bit GEKO SDS Plus 14 mm x 260 mm, model G61426

GEKO SDS Plus 14 mm x 260 mm drill bit, model G61426, is designed for rotary hammer drills with an SDS Plus chuck and intended for drilling into concrete, masonry and natural stone. With a 14 mm cutting diameter and a total length of 260 mm, this drill bit provides the working length needed to make through-holes and anchor holes for dowels, anchors or through-fixings on construction and renovation sites.

Advantages

The SDS Plus shank ensures fast and secure installation into the drill chuck and efficient power transfer during hammering action. The carbide tip improves wear resistance and maintains drilling performance when working with hard materials such as concrete and masonry. The overall length gives sufficient reach for medium-depth anchors while the 14 mm diameter corresponds to common anchor and plug sizes used in professional and DIY projects.

Suitable for

• Drilling anchor holes in concrete and reinforced concrete
• Creating passages for dowels and through-fixings in masonry walls
• Installing anchors for shelving, radiators and structural fixings
• General renovation and construction drilling tasks requiring 14 mm holes

Key specifications

• Shank type: SDS Plus
• Cutting diameter: 14 mm
• Total length: 260 mm
• Intended material: concrete, masonry, natural stone
• Tip material: carbide cutting tip for enhanced durability

How to use

Fit the drill bit into an SDS Plus rotary hammer until it locks in place. Select the hammer drilling mode on the tool and start drilling at low speed to establish a guide point, then apply steady pressure while allowing the drill's hammer action to break material. Periodically withdraw the bit to clear dust and debris from the hole, which improves cutting efficiency and prolongs bit life. For reinforcement or very hard material, use short drilling intervals to avoid overheating the tip.

Usage recommendations

Use appropriate personal protective equipment including safety glasses, hearing protection and dust mask. Match the 14 mm hole to compatible anchors or plugs and follow anchor manufacturer instructions for hole depth and cleaning. Avoid using the bit in rotary-only (non-hammer) mode for hardened concrete to prevent premature wear.