SAS to SATA Cable GIGABYTE 25CFM-600700-A4R SlimSAS 4i to 4× SATA 60 cm

The GIGABYTE 25CFM-600700-A4R SlimSAS 4i to 4× SATA 60 cm cable is an internal interconnect designed to convert a single SlimSAS (Mini-SAS) 4i interface into four separate SATA connections. At 60 cm length, this cable routes data signals from a RAID controller or backplane to individual 2.5" or 3.5" SATA drives within servers, workstations, or storage enclosures, enabling straightforward multi-drive configurations and support for hot-swap capable bays when the host hardware permits.

Advantages

This cable provides a compact, single-cable solution to break out a high-density SlimSAS port into multiple SATA channels without additional adapters. The design reduces cable clutter inside chassis while maintaining the signal routing required for RAID arrays or multiple independent SATA devices. Its 60 cm length balances reach and internal management for typical rackmount and tower layouts, and the direct-to-drive connections preserve standard SATA compatibility for HDDs and SSDs.

Suitable for

• Connecting a SlimSAS (Mini-SAS) 4i port on a RAID controller or backplane to up to four SATA drives
• Building or servicing servers, NAS, or storage enclosures that use SlimSAS breakout cabling
• Upgrading workstations or chassis to support multiple internal SATA drives from a single controller port
• Environments where cable management and drive accessibility (hot-swap support) are required

When it may not be suitable

This cable is intended for internal system use and is not suitable for external connections. It does not carry separate power rails; each SATA drive still requires appropriate power from the system power supply or backplane. It also does not convert between different signalling standards beyond SlimSAS-to-SATA breakout — it will not enable SAS device features unless supported by the host controller and backplane.

Key specifications

• Cable type: SlimSAS (Mini-SAS) 4i to 4 × SATA internal breakout
• Length: 60 cm
• Connector arrangement: one SlimSAS 4i input to four individual SATA outputs
• Intended use: internal data interconnect for HDDs and SSDs
• Compatible drive interfaces: SATA (standard data signals)

How to use

Install the SlimSAS end into the corresponding 4i port on the RAID controller or backplane, ensuring proper orientation and secure seating. Route the cable inside the chassis to avoid obstructing airflow or moving parts, and connect the four SATA ends to the respective drive connectors on HDDs or SSDs. Make sure each drive is supplied with power from the system power supply or a powered backplane. After connections, verify device detection in BIOS or the RAID controller utility and follow any controller-specific setup for RAID or individual drive configuration.

What to consider before purchase

• Confirm your controller or backplane has a SlimSAS (Mini-SAS) 4i port compatible with a 4-to-4 SATA breakout cable
• Ensure internal cable length of 60 cm is sufficient for your chassis layout and drive locations
• Verify that power delivery to each SATA drive is available via the PSU or backplane, as the cable does not supply power
• Check host controller support if you require SAS-specific features; this cable provides SATA signal breakout only

Usage recommendations

For reliable operation, route the cable away from high-heat components and secure it with ties or clips to prevent strain on connectors. Confirm firmware and controller compatibility before deploying in RAID configurations, and test drive detection after installation to ensure all four SATA channels are active.