Measuring gauge Gimex Przymiar półsztywny 1000 x 30 x 1 Inox (214.185)

Gimex Przymiar półsztywny 1000 x 30 x 1 Inox (214.185) is a semi-rigid stainless steel measuring gauge with a working length of 1000 mm and a flat profile 30 mm wide and 1 mm thick. Built in corrosion-resistant Inox steel, this measuring rule is intended for accurate linear measurements and layout operations where a stable, straight edge and durable material are required. Its semi-rigid design balances stiffness for precision with slight flexibility for alignment on uneven surfaces.

Advantages

The stainless steel construction ensures resistance to rust and long service life in workshop and construction conditions. The semi-rigid profile provides a reliable straight reference while allowing small bending for alignment or fitting into close spaces. The 1000 mm length covers standard measurement tasks and layout work without needing frequent joins, helping maintain measurement continuity. The thin, 1 mm profile reduces interference when used as an edge for scribing or marking.

Suitable for

• Linear measuring and marking in workshops and construction sites
• Layout work for carpentry, metalworking and tiling
• Use as a straightedge for scribing and cutting guides
• Routine inspection and verification of straightness over short runs

Key specifications

• Material: stainless steel (Inox)
• Length: 1000 mm usable measuring length
• Width: 30 mm
• Thickness: 1 mm
• Profile: semi-rigid flat rule suitable for straight-edge tasks

How to use

Place the measuring gauge along the surface or edge to be measured or marked, ensuring it sits flat where possible to maintain accuracy. Use the straight edge as a guide for scribing, marking cut lines or positioning measuring points. For layout across uneven surfaces, allow the slight flexibility of the semi-rigid profile to conform locally, then verify measurements with a secondary reference if high precision is required. After use, wipe clean and store flat to avoid permanent bending.

Usage recommendations

For best results, avoid dropping or applying excessive force that could cause permanent deformation. When working with fine tolerances, combine the gauge with a calibrated measuring tape or rule. Clean and dry the stainless steel surface after exposure to abrasive or corrosive materials to preserve the Inox finish and maintain consistent measurement performance.