Gimex Katownik 250/165 MKSA Kl.1 Inox — stainless steel corner bracket 250/165

Gimex Katownik 250/165 MKSA Kl.1 Inox is a stainless-steel corner bracket designed for mounting and reinforcing right-angle joints. With two leg lengths of 250 mm and 165 mm, the bracket provides a stable connection point for fixtures where corrosion resistance and mechanical strength are required. The MKSA designation indicates compatibility with matching mounting systems and fasteners commonly used in marine and outdoor applications.

Advantages

The bracket is made from stainless steel to resist corrosion in wet and salt-air environments while maintaining mechanical integrity. Its Kl.1 rating denotes a quality class suitable for structural support in light to moderate load conditions. The two-length configuration (250/165) offers flexibility in positioning and overlap, and the formed shape ensures consistent right-angle alignment for reliable installation.

Suitable for

• Reinforcing corner joints on metal or wooden frames
• Mounting shelving, cabinets or equipment in boats and marine installations
• Outdoor constructions exposed to moisture and salt air
• General fastening where stainless hardware is preferred

When it may not be suitable

This stainless-steel corner bracket is intended for light to moderate structural support; it may not be suitable for heavy-load structural applications where larger or load-rated brackets are required. The bracket provides a fixed right-angle connection and is not intended for adjustable or hinged joints.

Key specifications

• Material: stainless steel (inox)
• Leg lengths: 250 mm and 165 mm
• Configuration: fixed right-angle corner bracket
• Resistance: corrosion-resistant finish suitable for marine and outdoor use
• Quality class: Kl.1 (suitable for light to moderate loads)

How to use

Position the bracket so that both legs sit flush against the mating surfaces, ensuring the 250 mm and 165 mm legs provide the desired overlap. Mark and pre-drill holes in the substrate if installing into wood or metal, then fasten the bracket using appropriate stainless-steel screws or bolts compatible with the mounting system. Tighten fasteners evenly to avoid distorting the bracket and check alignment before final torque. For marine installations, use compatible corrosion-resistant fasteners and seal penetrations to prevent galvanic corrosion and water ingress.

What to consider before purchase

• Required leg lengths and whether 250/165 mm meets your overlap and mounting needs
• Load requirements to ensure Kl.1 class is adequate for the intended use
• Compatibility with existing fasteners and mounting systems (use stainless fasteners in corrosive environments)
• Substrate material (wood, aluminum, steel) and whether pre-drilling or special fasteners are needed

Usage recommendations

For best long-term performance in marine or outdoor settings, install with stainless-steel fasteners, apply appropriate sealant at penetrations, and avoid direct contact between dissimilar metals unless electrically isolated to reduce galvanic corrosion.