Soldering iron/station accessory GOOBAY 45246, 1 pc, length 1500 mm

Accessory for soldering iron/station GOOBAY 45246 supplied as a single unit. This desoldering braid is 1500 mm long and comes in compact packaging (50 × 50 mm). Made from fine pure copper mesh, it is designed as a replacement or spare component for compatible soldering tools and stations and is suitable for repair, maintenance and workshop use. The copper construction offers good thermal conductivity and resists oxidation and corrosion while leaving low residues on joints.

Advantages

The GOOBAY desoldering braid removes more solder than conventional wicks and is effective at correcting small defects on PCBs. Its pure copper mesh provides reliable heat transfer for efficient solder removal, low residue after use, and consistent performance without breakage points. Compact packaging and a 1500 mm length make it practical for multiple repair operations and professional maintenance tasks.

Suitable for

• Removing excess solder from through-hole and surface-mount joints
• Repairing and reworking small printed circuit boards (PCBs)
• Routine maintenance of soldering stations and electronic components
• Hobbyist and workshop electronics assembly and troubleshooting

Key specifications

• Material: pure copper mesh, oxidation and corrosion resistant
• Length: 1500 mm
• Packaging dimensions: 50 × 50 mm
• Function: desoldering braid for removal of solder residues
• Performance: good thermal conductivity, low residues, no fracture points

How to use

Place the desoldering braid directly over the solder joint to be cleaned. Heat the braid and the joint simultaneously with a soldering iron until the solder liquefies; the liquefied solder will be absorbed into the braid. Withdraw the iron and braid together once the solder has been drawn into the mesh, then trim or discard the used section of braid as necessary. For best results, use appropriate soldering tip size and temperature settings for the component and solder alloy in use.

Usage recommendations

Use steady, controlled heating and avoid excessive contact time to prevent damage to PCB pads and components. Replace sections of the braid after saturation to maintain efficient desoldering. Store in a dry place to preserve copper condition and avoid contamination before use.