Angle grinder accessory GRAPHITE 55H699 — 564 g, pack of 1

GRAPHITE 55H699 is an angle grinder accessory supplied as a single-piece pack and weighing 564 g. It is a cutting disc with an outer diameter of 230 mm and a 22.2 mm inner bore, intended as a replacement or spare part for compatible angle grinders. The disc has edges covered with tungsten carbide and is designed for cutting and surface preparation in metalworking and general construction tasks, as well as for repair, maintenance and tool customization.

Advantages

The tungsten carbide-covered cutting edges provide improved durability and cutting performance on softer construction and woodworking materials. The 230 mm diameter and 22.2 mm bore match common angle grinder sizes, allowing straightforward installation and stable operation. Supplied as a single unit and weighing 564 g, the accessory is easy to handle, store and fit during routine tool maintenance.

Suitable for

• Cutting wood and wooden boards
• Cutting chipboard and composite wood panels
• Cutting bricks and soft masonry
• Cutting plastics and gypsum board
• General repair and maintenance tasks with angle grinders

Key specifications

• Outer diameter: 230 mm
• Inner bore (arbor): 22.2 mm
• Edge material: tungsten carbide coating
• Net weight: 564 g (per piece)
• Pack quantity: 1 piece

How to use

Install the disc on a compatible angle grinder with a 22.2 mm arbor following the tool manufacturer’s instructions and secure it with the appropriate flange and lock nut. Ensure the grinder is unplugged or the battery removed during fitting. Check that the disc is mounted evenly and spins freely by performing a short no-load run before cutting. Use steady, controlled motions and allow the tool to reach full speed before engaging the workpiece; avoid excessive side pressure on the disc. Always use the correct guard and attachments for cutting applications and replace the disc if it shows visible damage or excessive wear.

Usage recommendations

Use appropriate personal protective equipment (eye protection, hearing protection, gloves and respiratory protection) and select cutting speeds and feed rates suitable for soft materials such as wood, chipboard, plasterboard, plastics and soft masonry. Do not use this disc on hard materials or where the manufacturer of the angle grinder advises against tungsten-carbide-edged cutting discs.