Drill bit GRAPHITE 6 mm spiral wood, cylindrical shank (57H273)

GRAPHITE spiral wood drill bit, 6 mm diameter with a cylindrical shank, is designed for drilling clean, precise holes in both soft and hard wood. The twisted flute geometry facilitates fast chip removal and stable drilling when used with hand drills or drill presses. Intended for general woodworking, furniture making and joinery, this 6 mm wood drill bit provides a straightforward solution for repetitive and single-hole operations where a small-diameter hole is required.

Advantages

The spiral design ensures efficient chip evacuation to reduce clogging and improve hole quality. The 6 mm diameter offers a standard size for dowels, pilot holes and small fasteners. The cylindrical shank is compatible with standard three-jaw chucks and bench drill chucks, providing secure clamping and stable rotation. The drill bit’s geometry supports straight, accurate drilling with minimal tear-out on exit when appropriate feed and speed are used.

Suitable for

• Drilling pilot holes for screws and dowels in furniture and cabinets
• General woodworking tasks in softwoods and hardwoods
• Use with hand drills, cordless drills and drill presses
• Carpentry and joinery where small, precise holes are required

Key specifications

• Drill type: spiral/twist wood bit
• Diameter: 6 mm
• Shank type: cylindrical (smooth) shank suitable for standard chucks
• Material application: designed for softwood and hardwood
• Flute: twisted flute for chip removal

How to use

Secure the drill bit in the drill chuck ensuring it is seated firmly and concentric. Select a drilling speed appropriate for the wood species—lower speeds for hardwoods and higher speeds for softwoods—and clamp or secure the workpiece to prevent movement. Align the bit at the desired point and apply steady, moderate feed pressure; avoid excessive force to prevent breakage of the 6 mm diameter bit. Withdraw the bit periodically on deeper holes to clear chips, or use continuous slow withdrawal if using a drill press to improve chip evacuation.

Usage recommendations

Use personal protective equipment including eye protection and a dust mask when drilling. For best hole finish, pilot or start with a center punch or awl to reduce wandering. When drilling laminated or veneered boards, apply backing support (sacrificial board) to minimize tear-out on the exit side.