Guide Bar 18" for Petrol Chainsaw GRAPHITE 58G952-73

Replacement 18" guide bar designed for petrol chainsaws, produced by GRAPHITE. The Guide Bar 18" for Petrol Chainsaw GRAPHITE 58G952-73 is intended to guide the saw chain and provide consistent cutting along its full length. It is engineered for use with compatible petrol chainsaws and suits general woodcutting, pruning and light to medium forestry tasks where an 18-inch bar is appropriate. Before purchase, verify compatibility with your chainsaw model and chain pitch.

Advantages

The bar offers a straight, reinforced rail profile that helps maintain chain alignment and reduces lateral vibration during cutting. Machined guide groove and hardened nose area improve wear resistance and extend service life compared with non‑hardened bars. Its 18" length provides a balance between cutting capacity and maneuverability for a variety of outdoor tasks. The bar is finished to resist corrosion and support consistent performance under normal working conditions.

Suitable for

• General woodcutting of logs and beams up to the capacity of an 18" bar
• Pruning and limb removal where longer reach than compact bars is needed
• Light to medium forestry and property maintenance tasks
• Replacement of worn or damaged bars on compatible petrol chainsaws

Key specifications

• Bar length: 18 inches (approximately 45 cm)
• Construction: hardened nose area with machined guide groove for chain seating
• Finish: corrosion-resistant coating
• Intended drive type: guide bar for petrol chainsaw applications
• Suitable tasks: general cutting, pruning, light to medium forestry work

How to use

Install the guide bar following the chainsaw manufacturer’s instructions: ensure the saw is switched off and the spark plug is disconnected before beginning. Fit the bar onto the mounting studs, align the chain on the bar groove and adjust chain tension according to recommended specifications. After installation, check chain lubrication and run the saw at low speed to verify proper alignment and tension. Regularly inspect the bar for wear, burrs or damage and maintain correct chain tension and lubrication to ensure safe operation.

Usage recommendations

The Guide Bar 18" is intended for use with compatible petrol chainsaws and should be paired with the correct chain pitch and gauge. Use appropriate personal protective equipment, maintain chain sharpness and lubrication, and replace the bar if significant wear or bending is detected to preserve cutting performance and safety.