Power drill accessory GRAPHITE 55H313 — 60 mm length, 5.5 cm diameter, 302 g, 1 pc

GRAPHITE 55H313 is a single-piece diamond hole cutter supplied in blister packaging. The tool has a length of 60 mm and a cutting diameter of 55 mm, with a total weight of 302 g. Designed as a replacement or spare accessory for compatible power drills and angle grinders with an M14 thread, this hole cutter is intended for precise cutting of hard materials including stone, porcelain stoneware, ceramic tiles, glass, asphalt, brick and concrete. Vacuum brazing and a diamond cutting edge concentrate cutting power in a small contact area to minimise the risk of cracking and ensure a consistent cutting performance for dry operation.

Advantages

The vacuum-brazed diamond edge provides increased wear resistance and longer service life compared with non-brazed cutters. A concentrated diamond cutting zone reduces chipping and surface damage while maintaining cutting accuracy. The single-piece construction ensures stable mounting and reduces vibrations during use. The standard M14 thread makes the accessory compatible with a wide range of drills and angle grinders that accept this connection type.

Suitable for

• Cutting circular holes in ceramic tiles and porcelain stoneware
• Creating openings in natural stone and engineered stone
• Drilling holes in brick and concrete for installations and fittings
• Cutting holes in glass and other brittle materials where controlled, dry cutting is required
• Work with asphalt where a diamond cutter is applicable for clean edge formation

Key specifications

• Cutting diameter: 55 mm
• Total length: 60 mm
• Connection type: M14 threaded mount
• Construction: single-piece diamond hole cutter
• Cutting edge: vacuum-brazed diamond
• Recommended operating mode: dry cutting
• Weight: 302 g

How to use

Securely fasten the hole cutter to a compatible power drill or angle grinder with an M14 threaded connection according to the tool manufacturer's instructions. Mark the centre point of the required hole on the material and start at low speed to establish a guide groove. Increase speed gradually and apply steady, even pressure without forcing the cutter. For tile, glass and stone, maintain a stable position to avoid lateral movement that can cause chipping. After completing the cut, withdraw the cutter while the tool is still spinning to reduce the risk of catching on the edge.

Usage recommendations

Use appropriate personal protective equipment including safety glasses, gloves and respiratory protection when cutting materials that produce dust. Even though the cutter is designed for dry cutting, avoid overheating by using intermittent operation and allowing the tool to cool between passes. Inspect the cutter for wear or damage before each use and replace it when the diamond edge becomes significantly worn to maintain cutting quality and safety.