Edge banding tape Haier KA-1848 33 mm x 3 m — white iron-on edging

Haier KA-1848 is a white iron-on edge banding tape 33 mm wide and 3 m long, created to finish and protect exposed panel edges. The tape features a heat-activated adhesive on the reverse side and a smooth white face that matches furniture and cabinet surfaces where a continuous white edge is required. It conceals raw substrate edges, resists everyday wear and provides a uniform, clean finish for worktops, shelving and joinery details.

Advantages

The iron-on construction simplifies application: bonding occurs with controlled heat, producing a durable seam without mechanical fasteners. The 33 mm width covers common panel thicknesses and the 3 m roll length is suitable for small- to medium-scale projects. The white face offers a neutral, consistent appearance that blends with painted or laminated surfaces while protecting edges from moisture and abrasion.

Suitable for

• Finishing exposed edges of cabinets and kitchen furniture
• Edge covering for worktops and tabletops with white surfaces
• Repairing or renewing damaged or worn edge trims on shelving and office furniture
• DIY joinery and small carpentry projects requiring a white seamless edge

Key specifications

• Color: white
• Application method: heat-activated (iron-on) adhesive
• Width: 33 mm
• Length: 3 m
• Face finish: smooth, uniform white surface
• Intended use: edge finishing and protection for furniture panels and worktops

How to use

Prepare the panel edge by ensuring it is clean, dry and free of dust, grease or loose particles. Cut a length of tape slightly longer than the panel edge. Position the tape with the adhesive side against the edge, then apply heat and even pressure with an iron or edge-banding tool according to the tool manufacturer's instructions to activate the adhesive and fuse the banding to the substrate. After cooling, trim any excess tape flush with a sharp utility knife or edge trimmer and smooth the seam to remove minor irregularities.

Usage recommendations

Use a temperature setting appropriate for melamine/laminate adhesives and perform a test on scrap material if unsure. Apply steady pressure during cooling to ensure full contact. For best results on highly porous or uneven edges, sand and seal the substrate edge before applying the tape.