Rotary Hammer Hikoki DH28PC 720 W 800 RPM SDS Plus, 3.2 J, 28 mm drilling

The Hikoki DH28PC is a corded rotary hammer designed for light-to-medium construction and renovation tasks. It features a 720 W AC motor, SDS Plus tool holder and delivers a maximum impact energy of 3.2 J. With a no-load speed up to 800 RPM and a drilling capacity up to 28 mm in concrete, this rotary hammer is intended for drilling anchor and through-holes, as well as light chipping and demolition in masonry and concrete. The tool weighs approximately 3.4 kg and has a recommended drilling depth of 316 mm.

Advantages

The rotary hammer combines a compact, corded design with an SDS Plus system for quick bit changes and reliable bit retention. Its 720 W motor balances power and manageability to provide steady drilling performance up to 28 mm in concrete while maintaining a modest weight for easier handling. The 3.2 J impact energy supports efficient drilling and light chiselling tasks without excessive vibration, and the 800 RPM maximum speed helps maintain progress on through-holes and anchor installations.

Suitable for (tasks / use cases)

• Drilling anchor holes in concrete and masonry
• Through-hole drilling for plumbing and electrical conduits
• Light demolition and chiselling in brick and concrete
• Installing anchors, dowels and fixings for construction and renovation
• General masonry and contractor site tasks requiring an SDS Plus rotary hammer

Key specifications

• Motor power: 720 W
• No-load speed: up to 800 RPM
• Maximum impact energy: 3.2 J
• Drilling capacity in concrete: up to 28 mm
• Tool holder: SDS Plus
• Weight: approximately 3.4 kg
• Recommended drilling depth: 316 mm

How to use

Secure the workpiece and select an appropriate SDS Plus drill bit for the required hole diameter and material. Insert the bit into the SDS Plus chuck until it locks, then set the machine to the drilling or hammer-drilling mode as needed. Hold the tool with both hands, apply steady forward pressure, and allow the rotary hammer's impact action to advance the bit; avoid forcing the tool. For chiselling tasks, select a chisel accessory and use controlled strokes. After use, disconnect the power, retract the bit and clean the chuck and ventilation slots to maintain performance.

Usage recommendations

The Hikoki DH28PC is best used for routine anchor and through-hole drilling and light chiselling where a balance of power and maneuverability is required. Use appropriate personal protective equipment, including eye, ear and respiratory protection, and select drill bits rated for concrete and masonry. For extended work sessions, monitor bit condition and periodically clear dust from the work area and tool vents to preserve cooling and performance.