Diamond Cutting Disc Hoegert 230 x 22.2 mm Turbo, model HT6D755

Diamond Cutting Disc Hoegert 230 x 22.2 mm Turbo, model HT6D755 is a turbo-rim diamond blade designed for handheld angle grinders. With a 230 mm diameter and 22.2 mm bore, this disc delivers a balance of cutting speed and controlled performance for abrasive building materials. The turbo rim profile helps evacuate dust and debris while maintaining a precise cut edge suitable for concrete, brick, masonry and natural stone.

Advantages

The turbo rim geometry provides faster cutting rates than a standard continuous rim while producing a reasonably smooth finish. Diamond grit segments bonded to the metal core ensure long life when used on hard materials, and the 22.2 mm bore fits common angle grinders with appropriate adapters. The disc construction reduces chipping on edges and supports efficient dust removal during operation.

Suitable for

• Cutting concrete slabs and blocks
• Trimming brick and masonry units
• Shaping and cutting natural stone and paving
• General renovation and construction cutting tasks with an angle grinder

Key specifications

• Diameter: 230 mm
• Bore (arbor) diameter: 22.2 mm
• Rim type: Turbo diamond rim
• Intended tool: Handheld angle grinder
• Primary materials: Concrete, brick, masonry, natural stone

How to use

Install the disc on a compatible angle grinder, ensuring the tool is switched off and unplugged or the battery removed during fitting. Tighten the flange according to the grinder manufacturer’s instructions and confirm the direction arrow on the disc matches the grinder rotation. When cutting, use steady, controlled feed rates and avoid excessive lateral pressure. Allow the diamond segments to do the work and let the blade cool periodically to extend its service life. Wear appropriate personal protective equipment such as eye protection, hearing protection, gloves and a dust mask.

Usage recommendations

For best results, use this turbo diamond disc for through-cuts and fast removal work on concrete and masonry. Wet cutting can reduce dust and extend disc life if the grinder and worksite conditions permit; otherwise, make intermittent cuts to avoid overheating. Replace the disc when cutting efficiency drops or if visible segment damage appears.