HOGERT HT6D464 is a 14-piece hole saw set with diameters from 19 to 75 mm designed for cutting circular openings in wood, plastics and similar construction materials. The set combines multiple commonly used sizes to cover a wide range of installation and repair tasks, allowing electricians, plumbers and DIY users to create neat, consistent holes for pipes, cable glands, conduits and fittings.
Advantages
The set offers a compact selection of fourteen hole saw sizes that reduce the need to change tools frequently during a single job. Hardened cutting edges provide reliable cutting performance in soft and medium-density materials while the stepped diameter range ensures precise fits for fixtures and conduits. The included pieces are arranged to simplify size selection and speed up repetitive cutting tasks.
Suitable for
- Creating openings for electrical boxes, cable glands and conduit entries
- Cutting circular holes for plumbing pipes and fittings
- Installing fixtures in wood, laminate and some plastics
- General repair and renovation tasks that require accurate round cuts
Key specifications
- Number of pieces: 14
- Hole diameter range: 19 mm to 75 mm
- Material compatibility: wood, plastics and similar soft/medium-density materials
- Design: circular hole saws with cutting teeth suitable for manual and powered drills (with appropriate arbor)
- Typical applications: installation of pipes, cables, fittings and fixtures
How to use
Select the hole saw diameter that matches the required opening. Secure the appropriate arbor in a drill, attach the chosen hole saw and tighten according to the arbor manufacturer's instructions. Mark the center of the intended hole on the workpiece, clamp the workpiece to prevent movement, and start drilling at low speed to establish the cut. Increase speed and apply steady, even pressure until the saw cuts through. After cutting, reverse the drill briefly or remove the arbor to clear the cut material and inspect the hole for fit.
Usage recommendations
Use a drill with compatible arbor and adequate power for the selected diameter. Clamp workpieces firmly, wear eye protection, and clear chips regularly to avoid overheating. For cleaner edges in thin or fragile materials, consider backing the workpiece with sacrificial board. Avoid using these saws on metal or very hard materials not specified for the set.
