Wire Stripper Pliers högert technik HT1P181 — automatic, 0.2–6 mm, 205 mm length

The högert technik HT1P181 automatic wire stripper pliers are engineered for controlled removal of insulation from electrical conductors. With a strip range covering 0.2–6 mm conductor diameters and an overall length of 205 mm, this hand tool combines an automatic stripping mechanism with a compact, ergonomic form to support routine electrical installation, maintenance and repair tasks.

Advantages

The automatic stripping mechanism ensures repeatable, consistent insulation removal while minimising the risk of nicking or cutting conductors. The tool’s length and handle design provide leverage and access in confined spaces. It supports a broad range of wire sizes within the stated 0.2–6 mm range, reducing the need for multiple dedicated strippers and speeding up workflow in repetitive operations.

Suitable for

• Stripping insulation from single-core and multi-core electrical wires within 0.2–6 mm diameter
• Electrical installation tasks in residential and commercial settings
• Maintenance and repair work on appliances, control panels and junctions
• Electrical hobbyist and DIY projects requiring precise, repeatable stripping

Key specifications

• Stripping range: 0.2–6 mm conductor diameter
• Tool length: 205 mm
• Operation: automatic stripping mechanism for controlled insulation removal
• Intended use: manual hand tool for electrical conductors

How to use

Place the wire into the stripper’s jaws at the desired insulation removal point, squeeze the handles until the automatic mechanism grips and cuts the insulation, then pull the tool away from the conductor to remove the insulation sleeve. Adjust positioning along the wire to change the stripped length. Always verify the conductor is within the indicated 0.2–6 mm range before stripping and inspect the conductor after each operation to ensure there is no damage to the metal core.

Usage recommendations

Use appropriate personal protective equipment and disconnect power before working on live circuits. For consistent results, choose wires whose diameter falls clearly inside the 0.2–6 mm range and perform a short test strip on a scrap piece of the same wire type prior to production work.