Insulation Stripper with Blade and Adjustment for Round Cables 8–28 mm Högert Technik HT1P189

The Högert Technik HT1P189 insulation stripper is a handheld tool designed for precise removal of outer insulation from round cables with diameters between 8 and 28 mm. It combines an adjustable stop and an integrated cutting blade to control strip length and depth, allowing consistent preparation of cables before termination. The tool is intended for electrical and telecom installations, maintenance tasks, and situations where reducing the risk of conductor nicking is important.

Advantages

The adjustable stop enables repeatable strip lengths and helps increase efficiency on repetitive tasks. The integrated blade provides a controlled cut of the outer insulation without the need for separate cutting tools. Its ergonomic handheld design allows single-person operation and better access to confined spaces. The tool’s construction focuses on protecting conductors from damage while delivering consistent results across the supported cable diameter range.

Suitable for

• Stripping outer insulation of round power and communication cables (8–28 mm diameter)
• Electrical installation and cable termination preparation
• On-site cable maintenance and repair
• Telecommunications and data cable assembly tasks

Key specifications

• Cable diameter range: 8–28 mm
• Handheld, manually operated design
• Adjustable stop for consistent strip length
• Integrated cutting blade for outer insulation
• Suitable for round multi-core and single-core cable types used in electrical and telecom applications

How to use

Position the cable inside the stripper until it contacts the adjustable stop and set the stop to the desired strip length. Close the tool around the cable so the integrated blade makes contact with the outer insulation. Rotate or slide the tool as required to cut through the insulation layer, then remove the cut section to expose the conductor. Check the conductor for any nicks or damage before proceeding to termination or connector installation. Adjust the stop and blade engagement as needed for different cable diameters within the supported range.

Usage recommendations

Inspect the blade regularly and replace it if dull to avoid tearing insulation or damaging conductors. Use the stripper only on cables within the specified 8–28 mm diameter range and follow standard safety procedures for electrical work, including de-energizing circuits before stripping. For consistent results, practice on scrap cable to set the correct blade depth and stop position for each cable type.