Clamping Bar Högert Technik HT3B937 quick-release woodworking clamp 300 x 63 mm

Clamping Bar Högert Technik HT3B937 quick-release woodworking clamp 300 x 63 mm is a manual clamp designed to hold wood and panel materials during gluing, assembly and sawing operations. The tool combines a fixed jaw with a sliding bar and a quick-release mechanism to allow fast repositioning and steady clamping pressure across the 300 x 63 mm clamping area. Its construction is intended for workshop and hobby use, offering a straightforward method to secure workpieces during common woodworking tasks.

Advantages

The quick-release mechanism enables rapid adjustment and repositioning of the clamp without the need to fully unscrew or reset the jaw, saving time during repetitive operations. A fixed jaw together with the sliding bar provides consistent pressure distribution, reducing the risk of movement or misalignment of glued joints or components. The clamp’s dimensions and profile are matched to typical woodworking panels and boards, making it practical for both assembly and light sawing support.

Suitable for

• Holding wood pieces during glue-up and drying
• Securing panels and boards for sawing and trimming
• Fixing small assemblies during routing or planing
• General workshop and hobby carpentry tasks

Key specifications

• Clamping area dimensions: 300 x 63 mm
• Quick-release adjustment mechanism for fast repositioning
• Fixed jaw with sliding bar for even pressure application
• Intended for manual operation in workshop and hobby environments

How to use

Place the clamp so that the fixed jaw contacts one side of the workpiece and the sliding jaw is positioned against the opposite side. Use the quick-release mechanism to open the sliding jaw, slide it to the required position along the bar, then engage the clamping action to apply pressure until the workpiece is secured. Check alignment of glued or assembled parts before final tightening. Release the clamp by disengaging the clamping action and using the quick-release to reposition or remove the workpiece.

Usage recommendations

Use protective pads between the clamp jaws and delicate or finished surfaces to avoid marks. Inspect the sliding bar and release mechanism periodically for debris or wear and keep moving parts lightly lubricated if needed. Avoid using excessive force beyond the clamp’s intended manual application to prevent damage to the tool or workpiece.