Network interface card HP Flex 1GbE Fiber LC Single Port for Z2 Mini G1a

HP Flex 1GbE Fiber LC Single Port for Z2 Mini G1a is a single-port 1 Gigabit Ethernet fiber network interface card engineered for HP Z2 Mini G1a workstations. It provides a fiber optic LC connector for stable, low-latency network connectivity over multimode or single-mode fiber runs depending on the network design. The module installs into the dedicated Flex I/O slot on compatible Z2 Mini systems and is intended to integrate workstation hardware into fiber-based LANs and backbone segments where optical connections are required.

Advantages

The card delivers a reliable 1 GbE fiber link with electrical isolation and immunity to electromagnetic interference, making it suitable for environments where copper cabling is impractical. Its single LC fiber port simplifies cabling and reduces connector bulk while preserving full Gigabit throughput. Designed to match HP workstation form factors, the module supports compact system integration and professional networking setups without external adapters.

Suitable for

• Workstation-to-switch connections in fiber-based office networks
• High-reliability data transfer between workstations and servers
• Environments with strong EMI where optical links are preferred
• Integrating Z2 Mini G1a into campus or data center fiber segments

Key specifications

• Interface type: 1 Gigabit Ethernet over fiber
• Connector: LC fiber optic single port
• Form factor: Flex I/O module for Z2 Mini G1a
• Transfer rate: Up to 1 Gbps full duplex
• Media: Optical fiber (single-mode or multimode as per network design)
• Operating temperature range: Conforms to workstation environmental requirements

How to use

Power down the Z2 Mini G1a and open the access panel according to the workstation service instructions. Insert the Flex module into the designated Flex I/O slot until it seats securely and replace any retention hardware. Connect an LC-terminated fiber patch cable to the module’s LC port, ensuring correct fiber type and polarity for the network link. After reassembling the system and powering on, verify link status through the operating system or network management tools and install any required drivers or firmware updates provided by the system vendor.

Usage recommendations

Use appropriate LC patch cords and fiber type that match the network infrastructure (single-mode or multimode). Handle fiber connectors with care to avoid contamination; inspect and clean connectors before mating. Follow HP service documentation for safe installation and ensure firmware/drivers are current to maintain compatibility and performance.