Heatsink kit HP for ProLiant DL380 Gen10 Plus — Standard heat sink, 620 g

Replacement heatsink kit HP for ProLiant DL380 Gen10 Plus — Standard heat sink, 620 g is a factory-compatible cooling component intended for use in HPE ProLiant DL380 Gen10 Plus servers. The kit provides thermal dissipation for the processor/module area to maintain operating temperatures within manufacturer specifications. It is designed as a like-for-like service part to restore original thermal performance after component failure or during maintenance and upgrades.

Advantages

This standard heat sink by HP offers direct thermal contact and a manufacturing quality that matches the original equipment, ensuring predictable cooling behavior in compatible server configurations. At approximately 620 g, the heatsink balances thermal mass with mechanical fit to integrate into the server chassis without modification. Using an OEM-equivalent part simplifies installation and reduces the risk of incompatibility compared with generic aftermarket solutions.

Suitable for

• Service replacement of a damaged or failed CPU heatsink in HPE ProLiant DL380 Gen10 Plus servers
• Routine maintenance or hardware refresh to restore factory thermal performance
• Upgrades where restoring or verifying proper cooling is required after component changes

Key specifications

• Compatibility: HPE ProLiant DL380 Gen10 Plus server models (standard CPU/module locations)
• Type: standard server heatsink / radiator for CPU/module thermal management
• Weight: approximately 620 g
• Form factor: designed to fit original mounting points and clearances in DL380 Gen10 Plus chassis
• Material characteristics: engineered for effective heat transfer and structural rigidity (OEM-grade construction)

How to use

Power down the server and follow approved service procedures including electrostatic discharge (ESD) precautions. Remove the server access panels and existing cooling assembly according to the service manual. Install the replacement heatsink in the same orientation, ensure correct seating on the processor/module, and fasten using the original mounting hardware or specified fasteners. Reapply thermal interface material where required and verify that adjacent airflow paths and fan assemblies are unobstructed before reassembly. After installation, perform appropriate system boot and thermal monitoring to confirm stable temperatures.

Usage recommendations

Use only in compatible HPE ProLiant DL380 Gen10 Plus systems and follow HPE service documentation for torque values, thermal interface application, and reassembly checks. Verify BIOS/firmware thermal settings and perform post-installation monitoring to ensure expected cooling performance.