IBP gas reducer tee 28x18x28 mm, brass fitting for gas piping

IBP gas reducer tee 28x18x28 mm, brass fitting for gas piping is a brass T-shaped connector designed to join three sections of gas pipe while reducing the bore on the middle branch. Intended for use in gas distribution systems, this fitting provides a durable metal junction that adapts a main 28 mm line to an 18 mm branch while maintaining two 28 mm run connections. The product is suitable for both residential and light commercial installations where an in-line reduction and branch are required, and it is compatible with standard gas piping practices when installed by qualified personnel.

Advantages

This brass gas reducer tee offers corrosion resistance and mechanical strength typical of metal fittings, ensuring long-term service in gas systems. Its T-shaped design allows a clean transition from a larger pipe to a reduced branch without adding multiple separate joints, reducing potential leak points when properly installed. The dimensional configuration 28x18x28 mm provides a straightforward solution for common pipe size transitions in gas distribution networks.

Suitable for (tasks / use cases)

• Creating a reduced-diameter branch from a 28 mm gas main to an 18 mm supply line
• Repairing or modifying existing gas pipe runs that require a T junction with a smaller bore
• Domestic and light commercial gas installations where brass fittings are specified
• Connections with standard gas connectors and compatible sealing methods

Key specifications

• Material: Brass
• Configuration: T-shaped reducer
• Connection sizes: 28 mm × 18 mm × 28 mm
• Application: Gas piping systems
• Typical use: In-line reduction and branching

How to use

Install the brass reducer tee in accordance with local gas installation regulations and standards. Ensure the gas supply is shut off and the system is depressurized before starting work. Prepare pipe ends by cutting squarely and deburring; then join the tee to the pipes using the appropriate method for the existing system (mechanical fittings, compression joints, or welded/soldered connections where applicable). Verify correct alignment and secure joints with specified seals or thread tape if threads are present, and tighten to the recommended torque. After installation, perform a pressure and leak test according to statutory requirements before returning the system to service.

Usage recommendations

Use this brass reducer tee only with compatible gas piping materials and within the pipe diameters specified (28x18x28 mm). Installation should be performed by a qualified gas engineer or competent installer. Always follow local codes, manufacturer guidance for sealing and tightening, and conduct leak testing after installation.