Gender changer adapter InLine 92504D — connector type unspecified

The InLine® Mini USB 2.0 terminal block adapter with 5-wire connection cable provides a compact solution for converting a mini USB 2.0 female socket into clearly labeled, screw-terminal wired signals. The permanently integrated approx. 1 m PVC cable and EVA insulating layer on the underside enable immediate use on control systems, test benches, diagnostic devices or mobile test stations without additional accessories or soldering.

Advantages

Tool-assisted screw terminals accept 16–26 AWG conductors and allow quick wiring with a flat-head screwdriver ≤ 2.5 mm. The 5-pin terminal block with pressure plate is clearly labeled (1: –, 2: D+, 3: D–, 4: +, 5: S) for unambiguous signal assignment. Electrical ratings such as 0.7 A per pin, an insulation resistance of ≥ 10 MΩ at 300 V DC and a 300 V AC test voltage ensure reliable signal transmission in industrial environments. The integrated 1 m cable reduces installation time and the EVA insulating layer protects when mounting on conductive surfaces.

Suitable for

• Test setups and laboratories
• Commissioning, service and troubleshooting
• Embedded systems and prototype development
• Mobile test stations and diagnostic equipment

Key specifications

• USB interface: Mini USB 2.0, female connector
• Cable length: approx. 1 m (PVC, permanently integrated)
• Number of pins / assignment: 5 terminals / 1: – / 2: D+ / 3: D– / 4: + / 5: S
• Connection technology: Screw terminal with pressure plate, 5.0 mm grid
• Connection range: 16–26 AWG
• Actuation: With flat-blade screwdriver ≤ 2.5 mm
• Rated current: 0.7 A per pin
• USB operating voltage (VBUS): 5 V DC
• Test voltage (insulation resistance): 300 V AC / 1 minute
• Insulation resistance: ≥ 10 MΩ @ 300 V DC
• Operating temperature: –20 °C to +105 °C
• Insulation layer: EVA insulation on underside
• Dimensions: Terminal block approx. 50 × 21.2 × 18.4 mm (L × W × H)

How to use

Connect the mini USB 2.0 female plug of the adapter to the corresponding male cable or device. Strip wires to the appropriate length and insert them into the matching labeled screw terminals (1: ground, 2: D+, 3: D–, 4: VBUS, 5: shield). Secure each conductor with the pressure plate using a flat-head screwdriver with a blade width ≤ 2.5 mm. Mount the adapter on a non-conductive surface or use the EVA insulating layer on the underside when placing it on conductive surfaces. The permanently integrated 1 m cable allows immediate connection to systems without additional soldering or accessory cables.

Usage recommendations

Use conductors within the specified 16–26 AWG range and observe the rated current of 0.7 A per pin. For reliable signal integrity, keep D+ and D– data lines twisted and avoid routing power and data lines closely in high-noise environments. Do not exceed the USB operating voltage of 5 V DC and avoid exposure beyond the stated operating temperature range.