Drill bit Irwin lip drill bit 6 mm, 1 pc

Irwin lip drill bit 6 mm is a single-piece lip-style bit designed for precise drilling in wood and similar soft materials. The bit features a centre point for accurate positioning at startup and a spurred cutting head that helps reduce splintering and produce clean edges. A fully hardened body increases wear resistance, while wide flutes enable fast chip evacuation for continuous drilling performance. The 6 mm diameter and cylindrical shank make it compatible with standard drills for common DIY and carpentry tasks.

Advantages

The centre point ensures easy and accurate starts without walking, improving hole placement. The fully hardened body provides enhanced durability and longer life under repeated use. The spurred cutting head minimizes tear-out on the workpiece surface for neater holes, and the wide flutes remove chips efficiently to prevent clogging and overheating. The simple cylindrical shank allows secure fitting in most drill chucks.

Suitable for

• Drilling clean 6 mm holes in softwood and plywood
• General DIY and home repair tasks
• Carpentry and joinery where precise small-diameter holes are required
• Fixture and hardware installation that requires a 6 mm pilot or clearance hole

Key specifications

• Drill type: lip/spurred point bit
• Diameter: 6 mm
• Total length: 93 mm
• Material compatibility: wood and similar soft materials
• Shank type: cylindrical
• Quantity: 1 piece
• Body hardening: fully hardened for wear resistance
• Flute design: wide flutes for fast chip removal

How to use

Mark the drilling position and secure the workpiece. Fit the 6 mm lip drill bit into the drill chuck and tighten firmly. Start drilling at low speed to allow the centre point to locate the mark, then increase speed appropriate to the material while maintaining steady pressure. Clear chips periodically if drilling deep holes to maintain cutting efficiency and reduce heat buildup. After use, clean the flutes and store the bit in a dry place to prevent corrosion.

Usage recommendations

Use the bit with a drill that supports steady speed control; lower speeds are preferable for hardwoods, while moderate speeds work well for softwood. Apply consistent, moderate pressure—excessive force can cause splintering or premature wear. For the cleanest edge on veneers and plywood, consider backing the workpiece to further reduce splintering.