Power cable set IVT for SW series inverter 2000 W, 2 m, 35 mm²

Power cable set IVT for SW series inverter 2000 W, 2 m, 35 mm² is a dedicated connection kit designed for IVT SW series inverters. The cable set provides a two-metre length and a 35 mm² conductor cross-section to ensure low electrical resistance and stable current flow between inverter and battery or distribution point. The product is intended for safe, fixed installations and replacements in residential and small commercial photovoltaic and backup power systems.

Advantages

The cable set offers a robust conductor size that minimizes voltage drop under high current loads and helps maintain inverter efficiency. Constructed for mechanical durability, the cables and terminals are suited for repeated tightening and secure clamping to inverter and battery terminals. The standardized length simplifies planning and installation while the insulation and conductor quality support reliable long-term operation in typical indoor or protected outdoor installations.

Suitable for

• Connecting IVT SW series 2000 W inverter to batteries
• Replacement of existing inverter power cables in residential PV systems
• Small commercial backup power and uninterruptible power setups
• Applications requiring low-resistance, short-length DC connections

Key specifications

• Cable length: 2 m
• Conductor cross-section: 35 mm²
• Intended use: DC power connection between inverter and battery/distribution
• Compatibility: IVT SW series 2000 W inverters
• Design: heavy-duty conductor with durable insulation for fixed installations

How to use

Before installation, ensure all power sources are disconnected and follow applicable safety standards. Route the cables to avoid sharp bends, abrasion and heat sources. Connect the positive and negative conductors to the corresponding inverter and battery terminals, observing correct polarity. Tighten terminal connections to the torque values specified by the inverter manufacturer and secure the cable runs with appropriate clamps or ties to prevent movement. After installation, inspect connections and perform system checks to verify voltage and functionality before commissioning.

Usage recommendations

Use the cable set in installations where a 2 m conductor length and 35 mm² cross-section meet voltage drop and current-carrying requirements. Avoid exposure to direct sunlight or unprotected outdoor conditions unless additional protection is provided. Periodically inspect terminal tightness and cable insulation for signs of wear, and replace the cable set if any damage or corrosion is observed.