Flue Pipe Jeremias TN0602100, length 1000 mm, diameter DN100 mm, with gasket

Jeremias flue pipe TN0602100 is a 1000 mm long venting section with an internal diameter of DN100 mm and an integrated gasket. It is intended for use as a connecting or extension element in chimney and flue systems to ensure a sealed joint between appliance outlets, ducts or existing chimney runs. The pipe is designed to provide a continuous, gas-tight passage for combustion products and to simplify installation where a one-metre DN100 segment is required.

Advantages

The DN100, 1000 mm length offers a standardized, modular solution that fits common small appliance and domestic chimney configurations. The integrated gasket reduces assembly time and helps maintain a reliable seal without additional sealing materials. The single-piece venting section facilitates alignment and extension of flue runs while minimizing leakage points.

Suitable for

• Extending DN100 chimney or flue systems by 1 m segments
• Connecting small heating appliances to exhaust ducts
• Replacing damaged or corroded pipe sections in existing flue runs
• Creating sealed joints between duct components in domestic ventilation and heating setups

Key specifications

• Length: 1000 mm
• Nominal diameter: DN100 mm
• Included sealing: integrated gasket for gas-tight connection
• Application: venting section for combustion gas exhaust systems
• Compatibility: intended for use with DN100 flue components and appliances

How to use

Measure the required run and insert the Jeremias DN100 pipe into the adjoining component until the gasket seats fully. Ensure mating surfaces are clean and free of debris before assembly. Align the pipe to avoid undue stress on joints, then secure with the appropriate clamps or fixing elements if required by the installation. Follow local regulations and the appliance manufacturer’s instructions concerning clearances and support intervals to maintain safe operation.

Usage recommendations

Regularly inspect joints and gaskets for wear or damage and replace any degraded sections. Use the flue pipe within systems designed for DN100 dimensions and verify material compatibility and temperature ratings with the rest of the flue system prior to installation.