Punch/Pin Driver Jonnesway Wybijak 6 x 180 mm model M63106

Jonnesway Wybijak pin driver 6 x 180 mm (model M63106) is a manual punch designed for driving and removing pins, knocking out dowels and aligning parts in metalworking and maintenance tasks. With a 6 mm diameter shaft and a 180 mm overall length, this tool provides the reach and stiffness required for controlled impact operations in workshops, automotive repair and machinery maintenance. The tool's solid construction and straight profile enable accurate strikes and stable guidance when used with hammers or mallets.

Advantages

The punch/pin driver offers a balance of reach and rigidity for accessing recessed pins while maintaining control during impact work. Its 6 mm diameter delivers adequate strength for common pin-driving and removal tasks without excessive material removal. The 180 mm length improves accessibility in assemblies with deeper pin locations. The simple, hardened-steel design minimizes deformation and ensures repeatable performance under typical workshop conditions.

Suitable for

• Driving and removing roll pins, cotter pins and dowels in automotive repair
• Aligning holes and parts during assembly and disassembly
• Light-to-medium metalworking and maintenance tasks in workshops
• Machinery servicing where controlled, precise impact is required

Key specifications

• Tip/shank diameter: 6 mm
• Overall length: 180 mm
• Material: hardened tool steel (typical for this tool category)
• Finish: raw or machined steel surface suitable for workshop use
• Tool type: manual pin driver / hand punch

How to use

Position the punch tip against the head or exposed end of the pin or dowel to be driven or removed, ensuring correct alignment with the hole axis. Hold the tool firmly and strike the opposite end with an appropriate hammer or mallet using controlled blows. For removal, work the pin gradually outwards by alternating strikes; for driving, continue until the pin is fully seated. Use eye protection and secure the workpiece to prevent movement during impact operations. Avoid excessive hammering that could overstress the punch or deform the workpiece.

Usage recommendations

Use protective eyewear and gloves when operating the punch. Choose a hammer size that provides controlled impact; avoid striking the tool at extreme angles. Inspect the punch for wear or mushrooming before use and dress or replace it if deformation is present. Store in a tool roll or holder to protect the tip and maintain straightness.