Expansion Plug Klimas KW-10/6X100 — anchor sleeve 6×100 mm for solid materials

Expansion Plug Klimas KW-10/6X100 — anchor sleeve 6×100 mm for solid materials is a mechanical fastening element engineered for use in solid base materials such as concrete and solid brick. The anchor sleeve accepts bolts and threaded rods to create a load-bearing connection for fixtures, supports and light structural components. Its 6×100 mm dimensions are intended for applications where a compact, reliable anchoring point is required and when consistent performance in solid substrates is needed.

Advantages

The anchor sleeve design ensures predictable expansion and even load transfer to the surrounding base material, promoting stable retention of the fastener. Its compact 6×100 mm size makes it suitable for confined mounting locations while still providing adequate embedment depth for common bolts and threaded rods. The mechanical construction requires no chemical adhesives or curing time, enabling immediate loading after installation when installed according to instructions.

Suitable for

• Mounting light structural supports and brackets to concrete or solid brick
• Securing fixtures such as handrails, signage and pipe clamps
• Fixing threaded rods for suspended or anchored assemblies in solid substrates

Key specifications

• Anchor type: mechanical expansion sleeve
• Diameter: 6 mm
• Length: 100 mm
• Intended base materials: solid concrete, solid brick and similar dense substrates
• Compatible fasteners: bolts and threaded rods sized to 6 mm nominal diameter
• Installation method: drill hole, insert sleeve, insert fastener and tighten to expand sleeve

How to use

Drill a hole in the base material to the specified diameter and depth for the 6×100 mm anchor sleeve, then clean the hole of drilling dust. Insert the expansion sleeve into the hole so it sits flush with or slightly below the surface. Place the bolt or threaded rod through the fixture and into the sleeve, then tighten to the torque recommended for the chosen fastener until the sleeve expands and engages the base material. Verify correct seating and load-bearing engagement before applying service loads.

Usage recommendations

Use in solid, dense substrates only; avoid hollow or soft masonry unless specifically approved. Match bolt grade and diameter to the expected load and follow relevant local codes and manufacturer torque recommendations. When in doubt about load capacities or substrate condition, consult a structural engineer or perform a pull-out test prior to critical installations.