Abrasive Hook-and-Loop Disc KLINGSPOR PS 18 EK 150 mm grit 60, pack 50 (MPN 270356)

KLINGSPOR PS 18 EK hook-and-loop abrasive discs, 150 mm diameter, grit 60, are designed for efficient sanding and material removal on a variety of surfaces. These discs fit orbital and random-orbit sanders with a 150 mm interface and feature a hook-and-loop backing for fast, secure mounting and quick changes during finishing and pre-finishing operations. The abrasive grain and backing are optimized for removal of paint, primer, and light stock from wood and soft metals while maintaining consistent cut rate and surface quality.

Advantages

The hook-and-loop backing ensures reliable attachment to compatible sanding plates and enables rapid disc replacement without tools. The 150 mm diameter provides broad coverage for faster sanding of flat and contoured surfaces. Grit 60 offers an aggressive cut suitable for stripping and shaping while balancing control to avoid excessive gouging on softer materials. The discs are supplied in a bulk pack to support continuous workflows and reduce downtime for reordering individual pieces.

Suitable for

• Sanding and removing paint or primer from wooden surfaces
• Surface preparation of soft metals before finishing
• Shaping and stock removal on timber and composite panels
• Pre-finishing sanding prior to coating or repainting
• Use with orbital or random-orbit sanders that accept 150 mm discs

Key specifications

• Disc diameter: 150 mm
• Abrasion grit size: 60
• Attachment: hook-and-loop backing for quick mounting
• Intended tools: orbital and random-orbit sanders with 150 mm interface
• Pack quantity: 50 discs
• Typical applications: wood, paint, primer, soft metals

How to use

Mount the abrasive disc onto a compatible 150 mm hook-and-loop sanding pad, ensuring the disc is aligned and fully seated on the backing plate. Start the sander at a low speed to check disc balance and operator control, then increase speed as appropriate for the material and task. Apply steady, even pressure and move the sander across the surface using overlapping passes to achieve uniform material removal. Replace the disc when cutting performance decreases or the abrasive surface shows visible wear; remove by peeling off from the hook-and-loop pad and attach a fresh disc.

Usage recommendations

For best results, use grit 60 for initial stock removal and coarse shaping, then progress to finer grits for smoothing and finishing. Maintain consistent feed and avoid dwelling in one spot to prevent uneven sanding. Match disc speed and pressure to the substrate: lower speeds and lighter pressure on delicate or thin materials, higher speeds and firmer pressure for thicker stock and heavier removal. Store discs flat and protected from moisture to preserve abrasive performance.