Diamond Segmented Cutting Disc KLINGSPOR K.TARCZA DIAM.SEG. 230 x 2.6 x 22 mm (MPN 334047)

KLINGSPOR K.TARCZA DIAM.SEG. 230 x 2.6 x 22 mm is a diamond segmented cutting disc designed for high-speed cutting of hard construction materials. The segmented rim provides improved cooling and efficient removal of debris, allowing sustained cutting performance when mounted on compatible angle grinders. The disc is intended for use in both professional and DIY settings where precise, fast cutting of concrete, masonry and natural stone is required.

Advantages

The segmented diamond rim reduces heat build-up and helps prevent clogging, extending cutting life during continuous operation. Its thin 2.6 mm cutting width offers a balance between fast cutting speed and low material waste. The construction of the disc provides stable cutting behavior with reduced vibration when used at appropriate speeds on standard angle grinders.

Suitable for

• Cutting reinforced and plain concrete
• Masonry block and brick cutting
• Natural stone and slate cutting
• On-site construction and renovation tasks

Key specifications

• Outer diameter: 230 mm
• Cutting thickness: 2.6 mm
• Bore diameter: 22 mm
• Segmented diamond rim for improved cooling and debris clearance
• Designed for use with handheld angle grinders at manufacturer-recommended speeds

How to use

Mount the disc on a compatible angle grinder with a 22 mm arbor and ensure the grinder is disconnected from the power source before installation. Check that the disc is free of visible damage and that the speed rating of the grinder does not exceed the disc's maximum operating speed. Secure the disc using the correct flange and tighten according to the grinder manufacturer's instructions. During cutting, maintain steady forward motion and apply moderate, even pressure; allow the disc to do the cutting rather than forcing it through the material. Use intermittent cutting or water cooling if required by the material and job conditions to control dust and heat.

Usage recommendations

Use appropriate personal protective equipment including eye protection, hearing protection, dust mask or respirator, and sturdy gloves. Operate the angle grinder with both hands and ensure the workpiece is securely clamped. Avoid side-loading the disc and follow local regulations for dust control when cutting silica-containing materials.