Abrasive flap wheel KLINGSPOR KM 613 20 x 20 mm grit 60

Abrasive flap wheel KLINGSPOR KM 613 20 x 20 mm grit 60 is a compact abrasive tool intended for surface finishing, deburring and edge blending on metal, wood and plastics. The design combines overlapping abrasive flaps around a central hub to provide controlled material removal and a consistent surface finish on small or curved workpieces. This flap wheel fits compatible rotary tools and small bench grinders for detail work and is useful where a small diameter abrasive contact is required.

Advantages

The KLINGSPOR KM 613 flap wheel delivers uniform cutting action thanks to the layered flap construction and medium coarse grit size. Its compact 20 x 20 mm dimensions allow access to tight areas and edges while maintaining good balance at typical rotary tool speeds. The abrasive composition and backing provide a predictable wear pattern for repeatable surface results and reduced risk of gouging on delicate parts.

Suitable for

• Surface finishing and satinizing small metal parts
• Deburring edges and removing flash on castings and stamped components
• Smoothing and blending joints on wood and composite materials
• Light rust, paint spot removal and surface preparation before painting
• Detail work with rotary tools and small bench grinders

Key specifications

• Wheel dimensions: approximately 20 x 20 mm (diameter x abrasive face width)
• Abrasive grit: 60 (medium coarse for material removal with visible finish)
• Construction: overlapping abrasive flaps on a central hub for flexible contact
• Suitable materials: ferrous and non-ferrous metals, wood, plastics and composites
• Tool compatibility: designed for use with compatible rotary tools and small bench grinders

How to use

Mount the flap wheel on the appropriate arbor or mandrel recommended for your rotary tool or bench grinder, ensuring secure fit and correct speed rating for the accessory. Start with light pressure and allow the wheel to contact the workpiece so the flaps conform to the surface; increase pressure gradually only if more aggressive material removal is required. Move the tool steadily across the work area to maintain an even finish and avoid concentrating on one spot to prevent overheating or excessive wear.

Usage recommendations

Use personal protective equipment including eye protection, gloves and appropriate dust extraction. For best results on metal, test on a scrap piece to confirm finish and adjust feed pressure. Replace the flap wheel when flap wear reduces effectiveness or balance is affected.