Diamond Cutting Disc KLINGSPOR DT 300F 125 mm — smooth, for wet/dry cutting

Diamond cutting disc KLINGSPOR DT 300F 125 mm is a smooth-rim diamond blade engineered for precise, clean cuts in hard masonry materials. The 125 mm diameter blade is designed for both wet and dry cutting, delivering a fine edge ideal for tile, ceramic and porcelain. The disc is compatible with standard 125 mm angle grinders and cut-off machines and is intended for professional and advanced DIY applications where minimal chipping and a smooth finish are required.

Advantages

The smooth rim profile provides clean, chip-reduced cuts and enables precise finishing on fragile surfaces. Engineered diamond grit ensures consistent cutting performance and long life on abrasive, dense materials. Wet and dry cutting capability adds versatility on site, allowing use with water cooling to reduce dust and heat or dry cutting when water is impractical. The 125 mm size offers a balance of maneuverability and cutting depth for common tile and masonry tasks.

Подходит для

• Резки керамической плитки и глазурованной плитки
• Резки фарфора и порцелана
• Работ по облицовке и тонкой подгонке краев
• Применений с угловыми шлифмашинами и отрезными станками с посадкой 125 мм

Key specifications

• Diameter: 125 mm
• Rim type: smooth / continuous rim
• Cut style: wet and dry cutting
• Intended materials: tile, ceramic, porcelain and similar masonry
• Typical use: precise, low-chipping finishing cuts

How to use

Mount the 125 mm diamond disc on a compatible angle grinder or cut-off machine following the tool manufacturer’s instructions. For wet cutting, apply a steady water supply to the cutting zone to reduce dust and heat and prolong blade life. For dry cutting, use light, steady feed pressure and allow the blade to cool periodically to avoid overheating. Maintain steady motion; avoid forcing the blade through the material to reduce chipping and extend rim life. Always use appropriate guards and follow personal protective equipment requirements.

Usage recommendations

Use the smooth rim disc for final finishing cuts and where minimal edge chipping is required. Prefer wet cutting for reduced dust and better cooling; for dry cutting use intermittent cutting and appropriate PPE. Inspect the blade for visible damage before each use and replace when diamond segments are worn or performance declines.