Side-cutting pliers Knipex 95 11 200 Cutting length 2 cm Steel

The Knipex 95 11 200 side-cutting pliers are precision hand tools designed for clean cutting of soft non-ferrous cables. With a total length of 200 mm and a 2 cm cutting length, these pliers combine compact dimensions and high cutting performance. Constructed from high-grade special tool steel that is forged and oil-hardened, they deliver reliable durability for repeated use. The tool is engineered to separate the cutting action into an initial cut for the insulating sheath and a final cut for the conductor, enabling one-handed cutting of cables up to 20 mm in diameter when used appropriately.

Advantages

Precision-ground, hardened cutting blades provide a clean and smooth cut without crushing or deformation of conductors. The favourable lever ratio and optimised cutting-edge geometry reduce the force required for cutting, while an adjustable bolted joint with a self-retaining screw ensures consistent blade alignment and long-term serviceability. A built-in guard protects the operator’s fingers from being pinched during use. The tool’s compact 200 mm length and moderate weight make it easy to handle in confined spaces and for extended tasks.

Suitable for

• Cutting copper and aluminium cables up to Ø 20 mm in diameter
• Electrical installation work where clean conductor ends are required
• Maintenance and repair tasks involving soft, non-ferrous wiring
• Workshop and on-site applications requiring a compact, durable cutter

Key specifications

• Total length: 200 mm
• Cutting length: 20 mm (2 cm)
• Material: high-grade special tool steel, forged and oil-hardened
• Weight: 283 g
• Blade: precision-ground, hardened
• Cutting capability: copper and aluminium cables; not suitable for steel wire or hard-drawn copper conductors
• Design features: adjustable bolted joint with self-retaining screw; finger guard; optimised cutting-edge geometry

How to use

Place the cable between the front and back cutting areas according to the intended action: use the front cutting area to slice through the insulating sheath and the rear cutting area to complete the conductor cut. Apply steady hand pressure, allowing the pliers’ lever ratio and cutting geometry to perform the cut with minimum effort. For cables up to 20 mm diameter, a one-handed operation is possible when the cable is positioned correctly. Do not attempt to cut hardened steel wire or hard-drawn copper conductors, as this will damage the blades.

Usage recommendations

Maintain the pliers by keeping the cutting edges clean and lightly oiled after use. Check and, if necessary, readjust the bolted joint to retain correct blade alignment. Use the tool only on materials specified—copper and aluminium cables—and avoid cutting steel or very hard wires to preserve blade hardness and precision.