Wood Screwdriver Bit KREATOR KRT010604 — 6 x 93 mm wood drill bit

KREATOR KRT010604 — 6 x 93 mm wood drill bit is designed for drilling clean, controlled holes in solid wood and common wood-based materials. The single-purpose bit fits standard hex or round shanks used in handheld drills and drill drivers and offers a combination of 6 mm diameter and 93 mm overall length to produce medium-depth holes for joinery, dowelling and furniture assembly. The geometry and cutting edges are optimized for wood to remove chips efficiently and reduce splintering at the exit side.

Advantages

The 6 mm diameter provides consistent hole size for dowels and fasteners, while the 93 mm length reaches moderate depths without excessive bending or wobble. The cutting design improves chip evacuation and helps achieve cleaner edges on the workpiece. Compatibility with common drill chucks and drivers makes the bit suitable for both cordless and corded handheld tools, simplifying tool selection for routine woodworking tasks.

Suitable for

• Drilling holes for dowels and screws in solid wood
• Creating pilot and clearance holes in particleboard and MDF
• Furniture assembly and cabinet making
• General carpentry and interior woodwork

Key specifications

• Diameter: 6 mm
• Total length: 93 mm
• Material suitability: solid wood and common wood-based panels (MDF, particleboard)
• Shank compatibility: suitable for standard drill chucks used with handheld drills and drivers
• Intended use: single-purpose wood drilling

How to use

Secure the workpiece and mark the drilling position. Insert the KREATOR 6 x 93 mm bit into the drill chuck and tighten securely. Start drilling at low speed to ensure correct centering, then increase speed as needed while maintaining steady pressure. Withdraw the bit periodically to clear chips when drilling deeper holes. After use, wipe the bit clean and store in a dry place to avoid corrosion.

Usage recommendations

Use appropriate personal protective equipment such as safety glasses and hearing protection. For the best finish, clamp the workpiece and consider backing material to reduce exit splintering. Match drill speed to the wood type—lower speeds for hardwoods and higher speeds for softwoods—and avoid excessive side load to prolong bit life.