Drill bit for wood KREATOR KRT010607 9 x 125 mm

Drill bit for wood KREATOR KRT010607 9 x 125 mm is a twist-type wood drill designed to produce clean, accurate holes in both softwoods and hardwoods. With a 9 mm cutting diameter and a 125 mm overall length, this bit is suitable for general woodworking tasks and can be used with handheld and stationary drills. The shank fits standard drill chucks, providing straightforward compatibility for common drilling equipment.

Advantages

The twist geometry and sharpened cutting edges deliver precise entry and reduced tear-out on wood surfaces. A balanced flute design helps evacuate shavings efficiently, lowering friction and preventing clogging during continuous work. The 125 mm length provides sufficient reach for most joinery and through-drilling applications while maintaining rigidity to minimise flex. Compatibility with standard chucks removes the need for adapters, enabling quick bit changes.

Suitable for

• Drilling holes in softwood and hardwood for joinery and dowelling
• Furniture assembly and repair tasks
• Carpentry and general construction drilling
• Use with handheld drills and drill presses

Key specifications

• Type: Twist drill bit for wood
• Diameter: 9 mm cutting diameter
• Overall length: 125 mm
• Shank: Straight shank for standard drill chucks
• Material: High-speed steel (typical for wood twist bits)
• Flute design: Spiral flute for chip evacuation

How to use

Secure the drill bit in the chuck and tighten according to the drill manufacturer's recommendations. Mark the drilling location and, if precise depth is required, use a depth stop or mark the bit with tape. Start drilling at low speed to establish the hole, then increase speed as needed while applying steady, even pressure. Clear accumulated shavings periodically to maintain cutting efficiency and avoid excessive heat build-up. For through-holes, support the exit side to reduce splintering.

Usage recommendations

Use the bit with appropriate drill speeds for the wood species being drilled, avoid excessive side pressure, and keep the cutting edges clean and sharp. Replace the bit if wear or chipping is observed to maintain hole quality.