Wood router bit KREATOR KRT013002 30 × 8 × 60 mm

Solid wood router bit KREATOR KRT013002 30 × 8 × 60 mm is designed for cutting, shaping and profiling wooden workpieces in handheld routers and router tables. With a 30 mm cutting diameter, 8 mm cutting width and 60 mm cutting length, this router bit delivers consistent edge work, grooving and trimming performance for carpentry, joinery and DIY woodworking projects. The tool is intended for use with standard router spindles and offers predictable results when used with appropriate speeds and feed rates.

Advantages

This KREATOR router bit provides precise, repeatable cuts and a clean surface finish on solid wood. Its geometry is optimized for efficient chip removal and reduced tear-out when working across and along the grain. The design supports stable clamping in both handheld routers and router tables, enabling accurate profiling and consistent groove dimensions during extended use.

Suitable for

• Edge profiling and trimming of solid wood
• Grooving and slot cutting in furniture components
• Joinery tasks such as tongue-and-groove and rabbets
• DIY woodworking projects and small carpentry jobs

Key specifications

• Cutting diameter: 30 mm
• Cutting width: 8 mm
• Cutting length: 60 mm
• Material compatibility: solid wood and common wood composites
• Shank type: standard shank for handheld routers and router tables

How to use

Install the router bit securely into the router collet following the router manufacturer's instructions, making sure the shank is fully seated and the collet nut is tightened. Set the router speed appropriate for the wood species and thickness, then make shallow passes to reach the final depth, especially when cutting across the grain or working with hardwoods. Use a router table fence or guide for straight profiles and a push block or featherboard for safe feed control. Allow the bit to cool between extended runs to maintain cutting performance.

Usage recommendations

Use proper personal protective equipment including eye and hearing protection. Inspect the bit for damage before each use and avoid excessive feed rates that can cause burning or premature wear. For best results, perform test cuts on scrap material to confirm speed and depth settings.