Gas concrete saw KREATOR KRT810001 — blade 650 mm, for cutting aerated concrete and masonry

KREATOR KRT810001 is a gas-powered concrete saw designed to accept a 650 mm cutting blade for on-site cutting of aerated concrete, masonry and similar building materials. The saw is intended for situations where electric power is unavailable or when a portable, robust cutting tool is required. Its configuration focuses on providing adequate cutting depth with compatibility for standard 650 mm diamond or abrasive blades commonly used for concrete and masonry.

Advantages

The gas concrete saw offers cordless mobility and rapid set-up on construction sites, enabling cutting operations without dependence on mains electricity. Its 650 mm blade capacity allows deeper cuts in a single pass compared with smaller hand saws. The tool is built for durability in construction environments and provides straightforward handling controls for operators familiar with petrol-driven saws.

Suitable for

• Cutting aerated concrete panels and blocks
• Making openings and joints in masonry walls
• On-site renovation and alteration work where electric supply is limited
• Roadside or remote cutting tasks on building sites

Key specifications

• Blade diameter: 650 mm (compatible with standard 650 mm blades)
• Power source: gasoline engine (portable, no mains required)
• Intended materials: aerated concrete, brick, blockwork and similar masonry
• Cutting depth: suitable for deep single-pass cuts when used with appropriate blade
• Handle configuration: designed for two-handed control and stable guidance

How to use

Before starting, fit a blade rated for the target material and ensure it is secured according to the manufacturer’s torque instructions. Check fuel and oil levels and inspect the saw for damage. Position the workpiece or the saw so the cut line is clearly visible and supported. Start the engine following the saw’s starting procedure, allow it to reach operating speed, then engage the blade and progress steadily along the cut line. Apply consistent forward motion without forcing the saw; allow the blade and engine to work at their intended speed. After cutting, stop the engine and allow the blade to come to a complete stop before setting the tool down.

Usage recommendations

Use appropriate personal protective equipment, including eye protection, hearing protection, cut-resistant gloves and respiratory protection against silica dust. When cutting aerated concrete or masonry, use wet cutting methods or dust extraction where possible to reduce airborne dust. Inspect blades regularly for wear and replace them when cutting performance decreases or damage is visible. Operate the saw on stable ground and keep bystanders at a safe distance while cutting.