Speaker cable kruger & matz KM0334 — 3.0 m, banana plug terminated

kruger & matz KM0334 speaker cable, 3.0 m long with banana plug terminations, provides a ready-to-install connection between an amplifier or receiver and loudspeakers. The cable features copper conductors and fixed-length construction to ensure consistent signal transfer over a 3.0 m run. Banana plugs at both ends allow quick, secure insertion into binding posts on amplifiers and speaker terminals without additional bare-wire preparation.

Advantages

This speaker cable offers straightforward installation with banana plug terminated ends that reduce connection time and improve contact reliability. Copper conductors provide good electrical conductivity for analogue audio signals, while the fixed 3.0 m length eliminates the need for on-site cutting or splicing. Insulation and connector housings are designed for home audio use, supporting stable speaker-to-amplifier connections in typical stereo and AV setups.

Suitable for

• Connecting bookshelf or floorstanding loudspeakers to an amplifier or receiver over a 3.0 m distance
• Home stereo systems and two-channel Hi‑Fi setups
• AV installations where fixed-length speaker runs simplify setup and cable management

Key specifications

• Length: 3.0 m
• Conductor material: copper
• Termination type: banana plugs at both ends
• Application: speaker-to-amplifier connections for home audio and AV systems

How to use

Ensure both amplifier/receiver and speaker binding posts are compatible with banana plugs and are powered off before connecting. Insert the banana plugs into the corresponding positive and negative binding posts on the amplifier and speakers, observing correct polarity to maintain phase. Route the cable to avoid sharp bends, heat sources, and high-traffic areas, and secure it with clips or ties if necessary. After connections are made, power on the system and verify correct speaker operation and balance.

Usage recommendations

For best results, keep cable runs as short and direct as practical, maintain correct polarity throughout the system, and avoid running speaker cables parallel to power cords to minimize potential interference. Inspect connectors periodically for secure contact and replace if any signs of wear or corrosion appear.