Connector for 8mm LED strip, Lamex LX1046 — double-sided snap with wires

Lamex LX1046 is a double-sided snap connector designed for 8 mm LED strips. It provides a mechanical and electrical connection without soldering, and comes with pre-attached wires for direct connection to power supplies, controllers or quick test rigs. The connector supports both single-color and RGB 8 mm LED strips and is intended for straightforward inline joining or for creating a pair of free wire ends for integration into a lighting circuit.

Advantages

The double-sided snap mechanism allows fast, tool-free installation while maintaining a reliable electrical contact. Pre-attached wires save time during installation and make the connector suitable for prototypes, repairs and small installations where soldering is impractical. The compact design fits standard 8 mm LED strip widths and reduces the need for additional connectors or terminal blocks.

Suitable for

• Joining two sections of 8 mm LED strip (RGB or single-color) without soldering
• Connecting LED strips to power supplies or controllers during installation or testing
• Temporary or semi-permanent lighting setups in residential and commercial environments
• Prototyping and quick repairs where speed and simplicity are required

When it may not be suitable

This connector is intended specifically for LED strips with an 8 mm width; it will not fit narrower or wider strip types. For permanently installed high-current runs or outdoor installations where sealing and strain relief are required, a soldered connection or weatherproof connector may be more appropriate. It is not designed as a waterproof or IP-rated solution.

Key specifications

• Type: double-sided snap connector with pre-attached wires
• Compatible strip width: 8 mm
• Supported strip types: single-color and RGB 8 mm LED strips
• Connection method: snap-in mechanical contact, no soldering required
• Wires: pre-attached leads for direct connection to power or controller (length varies by batch)
• Typical use: indoor lighting, prototyping, repairs and small installations

How to use

Open the snap cover, align the copper contacts of the 8 mm LED strip with the connector pads, insert the strip fully and close the cover until it snaps into place. Ensure the strip orientation and polarity match the connector markings. Use the pre-attached wires to connect to a compatible power supply or controller, observing correct voltage and wiring for single-color or RGB strips. For multiple segments, repeat the process for each side as needed.

What to consider before purchase

• Confirm your LED strip is 8 mm wide and has exposed copper contact pads that match the connector layout
• Verify required current and voltage compatibility for your strip and power supply
• Assess whether you need a waterproof or strain-relieved connection for outdoor or permanent installations

Usage recommendations

For reliable results, cut LED strips cleanly at the designated cut lines, ensure contact pads are free of adhesive residue, and test continuity before final installation. For longer or higher-current runs, consider multiple connectors or soldered joints to reduce voltage drop and heating.