Connector for 10mm RGB LED strip with wires and snap clasp, Lamex LX1075

Lamex LX1075 is a snap-type connector designed for 10 mm RGB LED strips and supplied with pre-attached wires for immediate connection. It enables joining or extending standard 10 mm RGB LED tape without soldering, providing a quick mechanical clamp and clear polarity alignment. The connector is intended for installers, hobbyists, and repair tasks where fast, tool-free connections and a compact profile are required.

Advantages

The snap clasp design allows instant connection to 10 mm RGB LED strips without the need for soldering, reducing installation time and the risk of heat damage to the strip. Pre-attached wires simplify wiring to a power supply or controller, while the mechanical contact design ensures consistent electrical conduction and secure retention. The compact form factor makes it suitable for tight spaces and quick repairs.

Suitable for

• Joining two segments of 10 mm RGB LED strip to extend runs
• Connecting an RGB LED strip to a power supply or RGB controller during installation
• Quick repairs or replacements of damaged strip sections in domestic or commercial lighting
• Prototyping and temporary setups where solderless connections are preferred

When it may not be suitable

This connector is designed specifically for standard 10 mm wide RGB LED strips; it may not fit narrower or wider strip types or those with non-standard pad layouts. It is intended for low-voltage LED lighting and not for high-voltage or mains connections. For permanent outdoor installations or environments with continuous moisture exposure, a sealed or IP-rated connection method may be more appropriate.

Key specifications

• Compatibility: standard 10 mm wide RGB LED strips
• Connection type: snap / clamp without soldering
• Wiring: pre-attached wires for quick connection to power or controller
• Contact: mechanical metal contacts for RGB pad alignment
• Application: indoor lighting, installations, prototyping, repairs

How to use

Open the snap clasp, align the copper pads of the 10 mm RGB LED strip with the connector contacts, then close the clasp until it locks. Ensure correct orientation so the R, G, B and + pads match the connector’s contacts. Route the attached wires to the power supply or RGB controller and secure connections by standard terminal or screw connectors. Confirm the strip lights as expected before finalizing mounting or concealment of the connection.

What to consider before purchase

• Confirm your LED strip width is 10 mm and pad arrangement matches standard RGB layout
• Check that pre-attached wire length and conductor type suit your installation needs
• Assess whether the connection will be exposed to moisture or mechanical stress that requires additional protection

Usage recommendations

For reliable operation, verify pad alignment and test the connected segment briefly before final mounting. Avoid repeated opening and closing of the clasp to maintain secure contacts, and where necessary use additional strain relief for the attached wires.