LED strip LEMLUX COB-06WW480-24-30M 30m, 24V DC, 6W/m, COB 480 LED/m, 660 lm/m, warm white 3000K, IP20, 180°

The LEMLUX COB-06WW480-24-30M is a continuous 30 m LED strip supplied for 24 V DC systems. It uses COB (chip-on-board) construction with a high LED density of 480 LEDs per metre to provide uniform, continuous warm white light at 3000 K. With a nominal power consumption of 6 W per metre and an approximate luminous output of 660 lm per metre, the strip is designed for interior applications requiring smooth, low-glare illumination along long runs. The strip is rated IP20 and emits light across a 180° beam angle.

Advantages

The COB architecture gives this LEMLUX strip a seamless lighting appearance with minimal visible point light, improving visual uniformity for cove, linear and accent installations. High LED density and a 180° emission pattern ensure wide coverage and even distribution of warm white light. Operating at 24 V DC and 6 W/m enables straightforward integration into low-voltage interior lighting systems, while the long 30 m reel supports extended continuous runs without frequent joins.

Suitable for

• Continuous interior linear lighting for coves and ceiling recesses
• Under-cabinet and task lighting where even warm white illumination is needed
• Accent and architectural outlining along long runs
• Shop displays and shelving illumination requiring low-glare light

Key specifications

• Length: 30 metres
• Operating voltage: 24 V DC
• Power consumption: 6 W per metre
• LED density: 480 LEDs per metre (COB construction)
• Luminous flux: approximately 660 lm per metre
• Correlated colour temperature: 3000 K (warm white)
• Ingress protection: IP20
• Beam angle: 180°

How to use

Install the LED strip on a clean, dry, and flat interior surface compatible with IP20 rating. Plan the 24 V DC power supply capacity to match the total length and overall power draw (6 W/m). Cut only at the designated cutting points if shorter runs are required and ensure correct polarity when connecting to the 24 V supply or to joiner cables. Use appropriate mounting profiles or adhesive backing suitable for continuous COB strips to maintain thermal contact and achieve even light distribution. Allow for ventilation and avoid running the strip where moisture protection beyond IP20 is necessary.

Usage recommendations

For long continuous runs, calculate total power and voltage drop to select a suitable power supply and, if necessary, inject power at intervals to maintain uniform brightness across the 30 m length. Use aluminium mounting channels for improved heat dissipation and to optimise light diffusion.