LED strip 5m reel LEMLUX COB-09WWW480-12IP65, 12V DC, 9 W/m, COB 480 LED/m, 900 lm, warm white 2700K, IP65, 180°

LEMLUX COB-09WWW480-12IP65 is a 5-meter LED strip on a reel intended for 12V DC low-voltage installations. The strip uses a COB (chip-on-board) array with a high LED density of 480 LEDs per meter, delivering approximately 9 W per meter and a luminous output near 900 lm in warm white 2700K color temperature. With an IP65 rating and 180° light emission, this LED strip is suitable for accent, under-cabinet, cove and protected outdoor applications where a continuous, glare-minimized light band is required.

Advantages

The COB LED construction provides a smooth, continuous line of light with reduced visible hot spots compared with traditional discrete-LED strips. Warm white 2700K offers a soft, inviting color tone suitable for residential and hospitality environments. The IP65 protection shields the strip from dust and water splashes, enabling installation in kitchen splash areas and sheltered outdoor locations. Low-voltage 12V DC operation simplifies wiring and compatibility with common LED drivers and battery systems. The 5 m reel length allows for longer continuous runs or multiple cut segments following the manufacturer's cut points.

Suitable for

• Under-cabinet and countertop accent lighting in kitchens
• Ambient cove and cornice lighting in living spaces
• Display illumination in retail shelving and cabinets
• Protected outdoor accent lighting on porches and covered walkways
• Low-voltage architectural and furniture integration projects

Key specifications

• Length: 5 meters (reel)
• Operating voltage: 12 V DC
• Power consumption: 9 W per meter
• LED type and density: COB, 480 LEDs per meter
• Luminous flux (approx.): 900 lm (per meter value is approximate)
• Color temperature: warm white, 2700 K
• Beam angle: 180°
• Ingress protection: IP65 (splash and dust resistant)
• Cuttable: cut points available along the strip (follow manufacturer markings)

How to use

Prepare a clean, dry mounting surface and plan the 12V DC power layout to keep voltage drop within acceptable limits for the run length. Cut the strip only at designated cut points and use appropriate connectors or soldering for electrical joins. Ensure polarity is correct when connecting to a compatible 12V LED driver or power supply sized to handle the total wattage. For IP65-rated strips, use silicone-filled connectors or suitably sealed junctions where joints are exposed to damp conditions. Mount the strip using the factory adhesive backing or mechanical clips on surfaces that are flat and free of dust and grease.

Usage recommendations

For optimal uniformity and to minimize voltage drop on long installations, plan power injection points every few meters and size the power supply to exceed total calculated wattage by 10–20%. Avoid direct exposure to heavy rain or immersion despite the IP65 rating; use IP67/IP68 solutions for fully submerged applications. When installing near heat-sensitive materials, ensure there is adequate ventilation or thermal management to prolong strip life.