LED strip LEMLUX COB-11WW480-24HE, 5 m reel, 24 V DC, 11 W/m, COB 480 LED/m, 3000K, IP20

LEMLUX COB-11WW480-24HE is a 5 m indoor LED strip on a reel designed for continuous linear lighting at 24 V DC. The strip uses a COB array with 480 LEDs per metre and a warm white color temperature of 3000K, delivering approximately 1,450 lm per metre and an efficiency around 137 lm/W. With a power consumption of 11 W/m and a 180° beam angle, the product provides uniform, high‑output illumination for accent, cabinet, shelf and general indoor applications. The strip’s IP20 rating indicates it is intended for dry indoor environments.

Advantages

The COB design produces continuous, shadow‑free linear light without visible point sources, improving visual uniformity along runs and reducing the need for diffusers. High luminous flux per metre and relatively high efficacy mean the strip can be used for decorative and stronger ambient lighting, and in many situations it can serve as primary illumination. The 24 V DC operation and 50 mm cut intervals allow flexible installation over long runs with fewer connectors, while the 8 mm width facilitates mounting in narrow channels or behind profiles. A 5‑year warranty supports longer term reliability expectations.

Suitable for

• Undercabinet and cabinet interior lighting
• Shelf, display and retail accent illumination
• Continuous cove and linear architectural lighting
• Worktops and task areas requiring warm white light

Key specifications

• Length: 5 m reel
• Supply voltage: 24 V DC
• Power consumption: 11 W per metre
• LED density: 480 LEDs per metre (COB)
• Light color: warm white, 3000 K
• Luminous flux: approx. 1450 lm per metre
• Lighting efficiency: approx. 137 lm/W
• Beam angle: 180° for wide, even illumination
• Strip width: 8 mm
• Cut interval: 50 mm
• Ingress protection: IP20 (indoor, dry locations)
• Warranty: 5 years

How to use

Verify a compatible 24 V DC constant voltage power supply sized to the total length (11 W/m × installed metres plus margin) and plan cable runs to minimize voltage drop. Cut the strip only at the marked 50 mm intervals and make secure solder or approved connector joints for electrical connections. Mount the strip on a clean, dry surface or within aluminium profiles for improved heat dissipation and mechanical protection. Ensure correct polarity when connecting to the power supply and, if dimming is required, use a compatible 24 V dimmer or driver designed for LED strips.

Usage recommendations

For uniform long runs and best visual result, install the strip inside a suitable aluminium extrusion with an opal diffuser. Keep the product for indoor use only and avoid exposure to moisture or direct contact with liquids. When planning runs longer than a single reel, use multiple feed points or larger gauge supply conductors to reduce voltage drop and maintain consistent brightness.