LED strip LEMLUX 5m, 12V DC, 13W/m, COB 528 LED/m, 1100 lm/m, cold white 6500K, IP20, free cut

LEMLUX COB LED strip, 5 m reel, delivers continuous cold white light at 6500K using a dense COB emitter that provides uniform illumination along the length. Designed for 12V DC installations, the strip produces approximately 1100 lumens per metre while consuming 13 W per metre. The product is rated IP20 for indoor use and supports free cutting at specified intervals, allowing installers to customize length for accent, task or cabinet lighting where even, shadow-free light is required.

Advantages

The continuous COB construction with 528 LED-equivalent emitters per metre produces smooth, glare-reduced light without visible point sources, improving visual consistency in proximity and under-cabinet applications. High luminous efficacy at 1100 lm/m combined with 13 W/m power consumption provides bright output with predictable energy use. The 12V DC operating voltage simplifies integration with common low-voltage power supplies and controllers. IP20 protection makes the strip suitable for indoor environments where direct exposure to water is not expected, and the free-cut design enables straightforward length adjustment during installation.

Suitable for

• Under-cabinet and kitchen counter illumination
• Cove, shelf and wardrobe lighting
• Task lighting for worktops, desks, and display cases
• Accent lighting in retail, offices and residential interiors

Key specifications

• Length: 5 metres on a single reel
• Operating voltage: 12 V DC
• Power consumption: 13 W per metre
• Luminous flux: 1100 lm per metre
• Colour temperature: 6500 K (cold white)
• LED density: COB equivalent 528 emitters per metre
• Ingress protection: IP20 (indoor use)
• Cutting: free cut at designated intervals for custom lengths

How to use

Measure the required length and cut the strip only at the marked cutting points. Prepare a compatible 12V DC constant-voltage power supply sized to handle the total length and power consumption (13 W/m × number of metres). Connect the strip to the power supply following polarity markings and, if needed, add a compatible dimmer or controller between the power supply and the strip. Secure the strip to a clean, dry surface using the adhesive backing or mounting profile, ensuring adequate heat dissipation and avoiding tight bends that could damage the COB emitter.

Usage recommendations

For longest service life and consistent light output, use a power supply with at least 10% headroom above the calculated load, avoid exposure to moisture, and allow ventilation or install in an aluminium profile to assist heat dissipation. When using long runs, consider power injection points to reduce voltage drop and maintain uniform brightness.