LOGILINK fiber optic coupler set FA03LC8 — 2× LC Duplex, SC-Simplex breakout, green, without flange

The LOGILINK fiber optic coupler set FA03LC8 provides a compact one-piece solution to couple and break out between LC duplex and SC-simplex terminations. Designed for use in fiber patch panels, network equipment, or inline adaptors, the unit offers two LC Duplex ports on one side and an SC‑Simplex breakout on the other. The green color identifies the connector type and helps with organized cabling. The product is supplied without a mounting flange for installations that require direct insertion into compatible housings or panels.

Advantages

This coupler set combines LC Duplex and SC‑Simplex interfaces in a single, space-saving module that simplifies cabling transitions between different connector types. Its one-piece design reduces alignment issues and supports fast installation in patch panels and adapter plates where a flange is not required. The green finish provides visual identification for fiber type or polarity management and helps maintain consistent cable organization.

Suitable for

• Fiber patch panels and adapter plates that accept non-flanged couplers
• Inline coupling where LC duplex to SC‑simplex breakout is required
• Network equipment or enclosures needing compact LC-to-SC transitions
• Laboratory setups and field repairs where quick connector adaptation is needed

When it may not be suitable

The coupler set is not supplied with a mounting flange, so it will not fit into panels or housings that require a flanged adapter for secure mounting. It is intended for standard LC and SC terminations; it is not suitable for connector types other than LC Duplex and SC‑Simplex. Installers should verify mechanical compatibility and panel cutout requirements before selection.

Key specifications

• Connector configuration: 2× LC Duplex to SC‑Simplex breakout
• Construction: one-piece coupler module
• Color: green (for visual identification)
• Mounting: without flange, designed for direct insertion into compatible housings or adapter plates
• Application: single-mode or multimode networks depending on installed connectors and fibers

How to use

Install the coupler by inserting it into a compatible adapter opening or enclosure designed for non-flanged modules. Connect LC Duplex patch cords to the LC side and an SC‑Simplex connector on the breakout side, ensuring proper alignment and endface cleanliness before mating. For reliable performance, clean connector endfaces with appropriate fiber cleaning tools and verify link continuity or loss using standard test equipment after installation.

What to consider before purchase

• Verify that your patch panel or enclosure supports non-flanged couplers and the physical dimensions of the module
• Confirm fiber type and connector polish (single-mode/multimode, UPC/APC) to ensure optical compatibility
• Ensure the green color matches your site identification scheme and polarity planning
• Check that a one-piece, non-flanged solution meets your mechanical mounting and strain-relief requirements

Usage recommendations

Use fiber cleaning tools before each mating, avoid excessive bending at the connector interface, and test each connection with an optical power meter or IL/OTDR to confirm acceptable loss values after installation.