LED bulb Lumax LL250 SMD Silicon G4 3W 3000K 200 lm

Lumax LL250 SMD Silicon G4 3W 3000K 200 lm is a compact G4-base LED bulb designed as a low-voltage replacement for small halogen lamps. The bulb uses SMD diodes under a soft silicon cover to deliver warm white light at 3000 K with an output of approximately 200 lumens while consuming just 3 watts. Its narrow form factor and G4 connector make it suitable for fixtures with limited space and for applications that require a discreet, warm accent light.

Advantages

The silicon-covered SMD design provides uniform light distribution and reduces visible glare compared with bare-diode bulbs. Low power consumption and reduced heat generation extend the service life of both the bulb and nearby fixtures. Its compact G4 footprint allows direct replacement of small halogen bulbs without major modification to the luminaire, while the warm 3000 K color temperature preserves color rendering suitable for indoor accent and display lighting.

Suitable for

• Display cabinets and retail showcases
• Accent and decorative lighting in living areas
• Small task lamps and reading lights with G4 sockets
• Under-cabinet lighting and kitchen accent fixtures
• Narrow-profile luminaires and recessed miniature fittings

Key specifications

• Base type: G4 bi-pin
• Rated power: 3 W
• Luminous flux: ~200 lm
• Color temperature: 3000 K (warm white)
• Light source: SMD LEDs with silicon diffuser
• Suitable voltage type: low-voltage DC/AC fixtures (verify fixture driver compatibility)
• Form factor: narrow, compact bulb for small luminaires

How to use

Ensure the luminaire is powered off and cooled before replacing an existing bulb. Remove the old G4 halogen or LED capsule by gently pulling it from the bi-pin socket, then insert the Lumax LL250 into the G4 socket until it is properly seated. Confirm that the fixture's transformer or driver supports LED loads and the supply voltage matches the lamp requirements. After installation, power on the fixture and allow a short stabilization period for the LED to reach steady light output.

Usage recommendations

For best results, use the bulb in fixtures rated for low-voltage G4 lamps and ensure compatibility with constant-voltage drivers or transformers. Avoid installing in fully enclosed, non-ventilated housings unless the fixture manufacturer confirms suitability for LED capsules. When replacing halogen lamps, verify that dimmer systems and drivers are LED-compatible to prevent flicker or reduced lifetime.