Powerful EcoFlow stations for energy anywhere!
In cart {{totalProductsCount}} item(s)
Your cart is empty
LED filament bulb MACLEAN MCE286 E14 6W 230V Retro Edison
MACLEAN MCE286 E14 6W 230V Retro Edison is an LED filament bulb that combines the visual appeal of a traditional Edison lamp with the efficiency of modern LED technology. With a small E14 screw base and a power rating of 6W designed for 230V mains, the bulb is intended for decorative and ambient lighting where a vintage look is required without high energy consumption. The clear glass and visible LED filaments recreate the warm, recognizable appearance of classic filament bulbs while delivering longer life and lower heat generation compared with incandescent lamps.
The bulb provides energy-efficient illumination at 6W while maintaining the aesthetic of a retro Edison lamp. Its E14 base makes it compatible with many decorative fixtures and smaller lamps. LED filament construction offers steady omnidirectional light distribution and reduced maintenance due to a longer expected service life. Operating on 230V mains, the lamp is ready for standard domestic and commercial installations without additional drivers.
Install the bulb into a compatible E14 socket while the power is switched off. After securing the bulb in the lamp holder, restore power and operate normally. Use the bulb in fixtures that allow for clear-glass or decorative lamps to achieve the intended visual effect. No external driver or transformer is required for standard 230V installations. Avoid using the bulb in fully enclosed luminaires unless the fixture is rated for LED lamps and provides adequate ventilation.
For optimal lifespan and light quality, operate the bulb within standard indoor ambient conditions and avoid frequent rapid on/off cycling. Suitable for indoor dry locations; protect from direct exposure to water or excessive humidity. When replacing incandescent bulbs with this LED filament lamp, verify compatibility with existing dimmer switches—use LED-compatible dimmers if dimming is required.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}