Bevel Brush Makita D-39849 115 mm – angled wire brush for surface cleaning

Makita Bevel Brush D-39849 115 mm is an angled wire brush designed for surface cleaning, rust and paint removal, and work along edges and tight areas. The 115 mm diameter and angled profile enable targeted contact with metal and other hard surfaces when used with compatible angle grinders. It is intended for preparatory tasks such as removing corrosion, old coatings and scale prior to painting or welding, and for routine workshop maintenance.

Advantages

The angled wire construction allows precise access to corners and edges while maintaining consistent brush contact on flat surfaces. Its 115 mm size is compatible with many compact angle grinders, offering a balance between working area and maneuverability. Robust wire filaments provide efficient material removal while the brush geometry reduces vibration transfer to the tool, helping maintain control during use.

Suitable for

• Removing rust and scale from metal surfaces
• Stripping paint or coatings in confined or angled areas
• Cleaning weld seams and preparing surfaces before welding
• General workshop maintenance and surface preparation

Key specifications

• Brush diameter: 115 mm
• Brush type: angled wire brush
• Intended surfaces: metal and other hard surfaces
• Compatible tool type: angle grinders that accept 115 mm accessories
• Primary functions: surface cleaning, rust and paint removal, edge and corner work

How to use

Fit the brush to an angle grinder that supports 115 mm accessories and ensure the tool is disconnected from power while mounting. Secure the brush according to the grinder manufacturer's instructions, check for correct seating and balance, and wear appropriate personal protective equipment including eye protection, gloves and respiratory protection if necessary. Start the grinder at low speed to verify stable operation, then use controlled strokes to work the brush across the surface. Apply consistent, moderate pressure—allow the brush filaments to remove material without forcing the tool. Avoid excessive sideways force that can cause rapid wear or create unsafe kickback. After use, disconnect the grinder and inspect the brush for wear or damage before storage.

Usage recommendations

Use the bevel brush for targeted cleaning tasks and surface preparation rather than heavy stock removal. Match brush speed and pressure to the workpiece material, and replace the brush when filaments are worn or deformed to maintain safe and effective operation.