Drill bit Makita D-76065 19 x 200 mm - SDS-plus, long masonry bit

Makita D-76065 19 x 200 mm is a long masonry drill bit designed for use with SDS‑plus rotary hammers. Intended for drilling into concrete, brick and blocks, this 200 mm length provides extended reach for anchor holes, through-holes and installation tasks. The 19 mm diameter balances hole size and chip removal for efficient progress when working on reinforced and non‑reinforced masonry.

Advantages

The SDS‑plus shank enables quick and secure tool engagement and easy bit changes without additional adapters. The long fluted body is engineered to evacuate dust and debris effectively, reducing friction and keeping the cutting edge focused on material removal. Balanced geometry ensures straight, stable drilling with minimal wandering. The construction is suitable for repeated use in professional and DIY environments where deeper or hard‑to‑reach holes are required.

Suitable for

• Drilling anchor and fixing holes in concrete and masonry
• Creating through‑holes for pipes or cables in brick and block walls
• Installation work requiring extended reach or deeper holes

Key specifications

• Diameter: 19 mm
• Total length: 200 mm
• Shank type: SDS‑plus
• Intended material: concrete, brick, masonry, block
• Flute design: long spiral for chip evacuation

How to use

Install the bit into an SDS‑plus rotary hammer according to the tool manufacturer's instructions until it locks securely. Select hammer drilling mode for concrete and masonry. Start at low speed to position the bit, then apply steady pressure and allow the tool to work; do not force the bit. Periodically withdraw the bit to clear dust and prevent clogging, especially when drilling deep holes. Use appropriate personal protective equipment such as safety glasses, hearing protection and a dust mask or dust extraction when required.

Usage recommendations

For best results, match drill speed and hammer power to the material density: lower speed for denser concrete and higher impact rate for standard masonry. When drilling reinforced concrete, progress slowly and withdraw frequently to clear chips. Use a vacuum dust extractor or intermittent withdrawal to reduce dust and extend bit life.