Rotary Hammer Makita HR3210C

The Makita HR3210C rotary hammer combines an 850 W motor with a maximum no-load speed of 630 RPM and an impact energy of 5.6 J to deliver reliable performance in concrete drilling and chipping. Designed as a successor to the HR3000C series, this model emphasizes reduced vibration and a compact, lightweight form factor at 4.9 kg to improve operator control during extended use. The tool supports forward and reverse rotation, a torque limiter to protect the bit and workpiece when hitting reinforcement, and three selectable operation modes for versatile application.

Advantages

Low vibration design and anti-vibration technology reduce operator fatigue and enhance handling. The torque limiter increases safety by stopping the bit when it contacts reinforcement. Built-in job light improves visibility in low-light conditions. Soft start and constant speed under load provide stable drilling performance, while the triple operation modes (rotary only, hammer only, rotary hammer) extend the tool's usability across different tasks.

Suitable for

• Drilling holes in concrete for anchors and fixings up to 32 mm diameter
• Light chiselling and surface preparation on masonry and concrete
• Through-holes and pilot holes in reinforced concrete when using appropriate bits
• General tradeswork where a durable, medium-weight rotary hammer is required

Key specifications

• Motor power: 850 W
• Maximum no-load speed: 630 RPM
• Impact energy: 5.6 J
• Maximum concrete drilling capacity: 32 mm
• Weight: 4.9 kg
• Operation modes: rotary only, hammer only, rotary hammer
• Forward/reverse rotation and torque limiter
• Soft start and constant speed under load
• Built-in job light
• Anti-vibration technology

How to use

Select the appropriate operation mode for the task: rotary-only for conventional drilling, hammer-only for chiselling, or rotary hammer for drilling in concrete. Fit a compatible SDS-plus bit and ensure it is securely seated. Set rotation direction as required and engage the torque limiter where reinforcement is likely. Start the tool with a steady grip using both handles, allowing the soft start feature to ramp up speed. Apply steady pressure without forcing the tool; the constant-speed control will maintain performance under load. After use, release the trigger, remove the bit, and store the tool in a dry place.

Usage recommendations

Use appropriate SDS-plus bits rated for concrete and reinforced materials. Wear eye, ear and respiratory protection when drilling or chiselling. When drilling near reinforcement, reduce feed pressure and allow the torque limiter to operate. Regularly check and replace worn bits to maintain efficiency and extend the service life of the rotary hammer.