Mitre Saw Makita LH1040

The Makita LH1040 mitre saw is a compact stationary saw designed for accurate crosscuts and angled cuts in wood and similar materials. Equipped with a 1650 W motor and a tungsten carbide-tipped blade of 260 mm diameter, the saw delivers consistent cutting performance with a maximum idle speed of 4800 RPM. Its cutting capacity at a 45° mitre is 53 x 95 mm, and a 2.5 m power cable gives freedom of placement on job sites and in workshops. The saw's overall dimensions (476 mm width, 530 mm depth, 535 mm height) enable installation on benchtops or stands where space is limited.

Advantages

The high-power 1650 W motor provides stable torque for demanding cutting tasks while the 260 mm tungsten carbide-tipped blade maintains cutting accuracy and durability. The relatively compact footprint and moderate weight make the saw easy to position and transport between work areas. A maximum idle speed of 4800 RPM contributes to clean, precise cuts and reduced splintering on wood sections. The included cable length increases setup flexibility without immediate reliance on extension leads.

Suitable for

• Crosscutting and mitre cuts in softwood and hardwood
• Trim, moulding and joinery work where accurate angled cuts are required
• Small workshop and on-site carpentry tasks
• DIY projects that require a compact yet powerful mitre saw

Key specifications

• Motor power: 1650 W
• Blade type: tungsten carbide-tipped
• Blade diameter: 260 mm
• Maximum idle speed: 4800 RPM
• Cutting capacity at 45° mitre: 53 x 95 mm
• Power cable length: 2.5 m
• Dimensions (W × D × H): 476 × 530 × 535 mm

How to use

Before operation, ensure the saw is placed on a stable surface and the power cable is routed safely. Fit the appropriate tungsten carbide-tipped blade and check that blade guards and clamps are working correctly. Set the desired mitre angle and secure the workpiece against the fence. Start the saw and allow it to reach full speed before lowering the blade through the material in a controlled motion. After completing the cut, raise the blade to its resting position and switch off the motor. Allow the blade to stop completely before removing the workpiece or performing adjustments.

Usage recommendations

Use suitable personal protective equipment such as safety glasses, hearing protection and dust mask. For best results with trim and finish work, clamp the workpiece firmly and use a sharp carbide-tipped blade designed for fine cutting. Regularly inspect and replace the blade when signs of wear appear, and keep the saw's working area clean to maintain accuracy and extend tool life.